Audiovalve SUNILDA 2013 Manual de instrucciones - Página 11
Navegue en línea o descargue pdf Manual de instrucciones para Amplificador Audiovalve SUNILDA 2013. Audiovalve SUNILDA 2013 14 páginas. Ultra highend riaa mc and mm phono amp
Imprimir páginaSUNILDA
ultra highend phono tube amplifier____________________________
If connecting only one system, please use the input 1 according to the marking at the back of
the appliance. Make sure the cinch cables as well as the adjacent earth conductor are well
fitted.
At the right of the front screen you will find a row of flip switches ( little rocker switches ).
Only the switch in the middle – to be actuated at level – indicates the input to be used by
yourself. Flip this switch to the left, if you have configured to input 1 at the back. Flip it to the
right, if you have also configured to input 2 and intend to use both inputs.
There is an additional switch each at the right and at the left of the level flip switch
– to be
actuated vertically – assigning the connected pick-up by model to the respective input. The
flip switch is flipped upwards, if a MC system is connected to the respective input and is
flipped downwards when connecting a MM system.
The very left switch of all 4 flip switches can M U T E the output signal, if being flipped
upwards (yellow LED) or can change into STAND - BY mode (red LED) with the switch pointing
downwards.
In this case SUNILDA is heated up without anode supply voltage. With the switch in neutral
position none of these two functions are active. This switch position is neutral and usually the
prefered position.
Relevant information:
Whenever one of these 4 flip switches is actuated, the outputs of the phone pre-amplifier are
muted – for a period of 15 secs. – to suppress the internal voltage variations at the output. This
is for safety control only. When you worried about your speakers, please adjust the pre amplifers
volume potentiometer downwards, so that no signal spikes can be reach your power amplifier and
speakers.
I MP E D A NC E
By means of the four rotary knobs at the left side of the front screen the impedances for the
pick-up's are selected for both outputs independantly from each other.
Looked at from the middle the knobs are in a mirror-inverted position,
i.e.
the
two
middle rotary knobs select the load resistance for the pick-ups: the middle left knob for
input 1 and the middle right knob for input 2. By means of the outer rotary knobs the
appropriate leading load for the individual input is selected. You may change these settings at
the amplifier, if required.