DAPAudio D4510 Manual - Página 7
Navegue en línea o descargue pdf Manual para Amplificador DAPAudio D4510. DAPAudio D4510 16 páginas.
Imprimir página
CA-2150
Power Switch ON/OFF
Flick the switch to turn the device on/off.
Gain control (CH A)
Turn the control to set the channel's gain level.
CLIP, SIGNAL, PWR, PROT LEDs
CLIP: When the LED lights in red, it indicates distortion. In this case, decrease your source signal
level until the LED turns off. Please keep in mind that the amplifier itself cannot correct any
distortion.
SIGNAL: When the LED lights in green, it means that the CA is operating within its safety limits.
PWR: The LED will light in blue when the CA is switched on.
PROT: The LED will light in red when the amplifier is in protection mode. Switch off the device and
find out what the problem is. The amplifier is protected against overheating, overload, short
circuit, etc. Decrease the source signal level and/or improve air circulation in the room where
the CA is installed.
Gain control (CH B)
Turn the control to set the channel's gain level.
Air intake grill
Backside
Mode button
Repeatedly press the button to switch between the 2 operation modes: stereo and bridge.
STEREO: Input A (10) to CH A amplifier (15), input B (07) to CH B amplifier (14)
BRIDGE: Input 1 to mono bridge amplifiers
CH B, 3-pin XLR connector IN (unbalanced/balanced)
Connect low impedance equipment with balanced/unbalanced line level outputs.
CH B, 6,3 mm jack line level connector IN
Connect a line level source.
Limiter switch
Press the button to toggle the built-in limiter on/off.
CH A, 3-pin XLR connector IN (unbalanced/balanced)
Connect low impedance equipment with balanced/unbalanced line level outputs.
CH A, 6,3 mm jack line level connector IN
Connect a line level source.
Air exhaust
Do not block the air exhaust as it may cause overheating and/or other serious damage.
CH B, 6,3 mm jack speaker connector OUT
Connect the device to speakers.
CH B, Speakon speaker connector OUT
Connect the device to speakers.
CH A, Speakon speaker connector OUT
Connect the device to speakers.
CH A, 6,3 mm jack speaker connector OUT
Connect the device to speakers.
210-240V AC, IEC power connector IN + Fuse T4AL/250V
Ordercode: D4510
6
Fig. 02