Duratech LINK Touch DLT10-RGB Manual - Página 8
Navegue en línea o descargue pdf Manual para Mando a distancia Duratech LINK Touch DLT10-RGB. Duratech LINK Touch DLT10-RGB 14 páginas.
Imprimir página
FW V2.1 Cover Calibration in combination with DLM or DLC-010
SETTINGS
Cover settings
enter
SETTINGS
Cover calibr
start
COVER CALIBRATION
DIRECTION
FORWARD
COVER CALIBRATION
POSITION
OPEN
COVER CALIBRATION
POSITION
CLOSE
COVER CALIBRATION
CONFIRM ?
STORE
14
Go to "Cover settings enter" in the
settings menu touch screen to enter
Touch the screen and select "COVER
CALIBRATION START ".
Press the cover close icon on the Link
Touch for direction forward. Verify
if the cover closes when pressing
the cover close symbol. If not press
the on/off button once "direction
forward" will change to "direction
reverse" this will change the polarity.
Press the right arrow to confirm and
go to the next setting.
Press the cover open logo on the Link
Touch until the cover is fully opened.
To confirm and go to the next setting
press the right arrow.
Press the cover close logo until the
cover is fully closed. To confirm and
go to the next setting press the right
arrow.
Press the on/off icon to confirm the
calibration settings
Buzzer settings
The buzzer sound can be set to ON or OFF. If set to ON, then the buzzer
will sound each time as confirmation for touching any of the active areas
of the LinkTouch
TM
. The beep will also sound when the House of Duratech's
DuraCover is in operation. In case of a third party cover, the beeping sound
will not be active.
SETTINGS
Buzzer
Enabled
SETTINGS
Buzzer
Enabled
Warning :
It is advised to set the buzzer setting to "ON", in order to have an audio
feedback during the operation of the cover.
Go to "BUZZER" in the settings menu.
Touch the screen to select the
required operation mode. (note that
default setting is set to "BUZZER
ENABLED".
15