Duratool D00674 Manual de inicio rápido - Página 5
Navegue en línea o descargue pdf Manual de inicio rápido para Pistola de soldar Duratool D00674. Duratool D00674 8 páginas. 80w soldering & rework station
Imprimir página
•
If the difference between the required temperature and that of the iron tip is greater
than 10° "WAIT" displays on the LCD.
•
To change from °C to °F press
the temperature figure.
•
When the desoldering tip reaches the desired temperature place over the solder
connection on the back of the PCB.
•
When the solder melts, pull the trigger on the desoldering iron.
•
The solder will be collected in the reservoir on the top of the iron.
•
If the tip becomes blocked use the correct size cleaning wires (supplied) to clear
the blockage.
MAINTENANCE
Removing solder waste:
The reservoir must be emptied of solder waste regularly or the efficiency of operation
will be impaired.
•
Switch off the mains power and allow the desoldering gun to cool.
•
Slide the rear cover clear from the reservoir.
•
Lift out the reservoir while retaining the filter pad
and spring plate in position.
•
Remove the filter pad and spring plate and empty
out the waste from the reservoir.
•
Replace the spring plate and filter into the rear end of the tube and re-insert into
the gun ensuring the spring plate and filter are fully engaged inside the tube and
the front end is slotted into the gun fully.
•
Press on the end of the rear cover and slide it back into position.
NOTE: a new filter pad can be fitted during this process if the one in use is becoming
dirty or worn.
Replacing the desoldering tips:
•
There are 3 different diameter tips supplied with this iron.
•
Replacing the tip should only be done when the iron is switched off, unplugged
and allowed to cool.
Caution: Damage could occur if the iron is left powered on without the tip fitted.
•
Unscrew the knurled nut and remove the outer
tube retainer.
•
Invert the tube and the tip will drop out.
•
After removing the tip, blow out any oxide dust
that may have formed in the tip retaining area of
the iron.
Caution: Care should be taken to avoid getting dust in your eyes.
o
o
C /
F button
. The display shows °C or °F after
5