Belimo ZIP Economizer Instrucciones de montaje

Navegue en línea o descargue pdf Instrucciones de montaje para Accesorios de audio y vídeo Belimo ZIP Economizer. Belimo ZIP Economizer 2 páginas. Energy module
También para Belimo ZIP Economizer: Instrucciones de montaje (4 páginas), Instrucciones de montaje (2 páginas)

Imprimir página
MOUNTING INSTRUCTION
ZIP Economizer
Installation
Each ZIP Economizer module is designed with a unique form fi t which allows it
to fi t only in one location on the ECON-ZIP-BASE.
Insert the ECON-ZIP-EM module in the center designated slot of the ZIP
Economizer base unit. Illustration located below for location.
Press fi rmly to lock the module in place – you will hear a snap.
™
Energy Module
Removal of ECON-ZIP-EM
Insert a fl at head screw driver into the latch of the module. Apply light
pressure on the latch away from the base unit. Lift up to remove.
ECON-ZIP-EM
Technical Data
Type
Name
Description
CO2 sensor
Input
CO2 +/-
input
Indoor fan
Output
IF
low speed
enable
Exhaust fan
Output
EF
enable
Auxiliary input
Input
AUX1 ±
Purge contact
input
Auxiliary input
Remote
Input
AUX2 ±
Potentiometer
Input
Electrical Specifi cation
0-10 VDC
Sensor auto-detection
100'000 cycles @ inrush current
of 3A, normal current 1.5A
Impedance for Auto detection
@24 V:
<600 Ω @ 60Hz
<800 Ω @ 50Hz
100'000 cycles @ inrush current
of 3A, normal current 1.5A
Impedance for Auto detection
@ 24 V:
<600 Ω @ 60Hz
<800 Ω @ 50Hz
On/Off, 24 VAC, 50/60 Hz
Current load min. 10mA
2-10 VDC
1