DAPAudio DS-CM-10 Manual del producto - Página 10
Navegue en línea o descargue pdf Manual del producto para Equipo para DJ DAPAudio DS-CM-10. DAPAudio DS-CM-10 17 páginas. Dj mixer
Imprimir página21. X-assign B
Use this switch to assign the Left-side of the crossfader (20) to an input channel (zero is Off).
22. Fader Start B
This switch activates the fader start function for the channel selected by X-assign B (21).
29/ 36. Zone EQ Treble/Bass
The Zone's Equalizer section allows shaping of the incoming audio signal. The Mic channel is fitted
with a 2-band EQ. The Treble (29) and Bass (36) shelving controls have their frequencies fixed at
12 Khz and 80 Hz respectively. The treble band has up to 15 dB cut and up to 12 dB boost. The bass
band has up to 30 dB cut and up to 12 dB boost.
30. Master Fader
This fader allows you to adjust the output signal to the Master (26) output.
31. Cue Mixer
Use this control to make a headphone mix between your Cue and your master signal.
32. Split Cue Switch
This switch controls the routing to your headphone. In split mode the Cue signal is send to the Left ear
of the headphone connected to the Phones (35) output. The Program (Master) signal is send to
the Right ear of the headphone. In normal mode the Cue and Program (master) signal are send to
both ears of the headphone.
33. Cue Level
This control allows you to adjust the Phones (35) output.
34. Zone Volume
This control allows you to adjust the volume of the Zone (45) output.
35. Phones
You can connect a pair of headphones with an impedance of 32 - 600 Ohm to the headphones
connector. It is a 6,3mm/ 1/4" TRS socket, wired as Tip=left, Ring=right and sleeve = ground.
Caution: Depending on the type of headphones connected to the Headphones jack, the DS-CM-6 is
capable of producing high output levels via the phones output. Therefore, make sure to turn the
control all the way to the left (minimum setting) before connecting the headphones. Be aware of the
fact that listening to loud sound pressure levels over a longer period of time leads to hearing-
damage!
23. Output L Signal VU Meter
This meter is a multi-step LED; respectively the green LEDs show
-40, -30, -20, -10, -7, -4 and -2dB. The red LEDs show +0, +2, +4, +7
and +10dB. The accurate level indication allows you to monitor
the output signal level at anytime, and match with other
devices.
24. Balance
Use to set the balance between the Left and right master
output.
25. Output R Signal VU Meter
This meter is a multi-step LED; respectively the green LEDs show
-40, -30, -20, -10, -7, -4 and -2dB. The red LEDs show +0, +2, +4, +7
and +10dB. The accurate level indication allows you to monitor
the output signal level at anytime, and match with other
devices.
26. Aux 3,5mm jack stereo input
Use to connect a line level device i.e. IPod etc.
27. Power On/ Off Switch + Power LED
Do not supply power before the whole system is set up and
connected properly. If switched On, the LED (at the left side of
Fig. 5
the switch) will light up.
28. Light BNC Connector
For racklight 12V max. 5W. E.g. DAP D60724, D60725.
8