Duratuf KIWI MK1A Manual de instrucciones de montaje - Página 12

Navegue en línea o descargue pdf Manual de instrucciones de montaje para Almacenamiento exterior Duratuf KIWI MK1A. Duratuf KIWI MK1A 16 páginas.

Step 1: Position Door Track (107) on front wall up against

underside of Roof, with right hand end flush with the

right hand corner. Pre-drill hole in centre and rivet in

place. Remove ALL drill filings

Step 3: Remove Door. Pre-drill holes into each Rib and at

similar spacings into Over Door Flashing. At ap-

proximately 1/3 in from each end of Door Track put

a 50mm nail. Fix rivets to rest of holes

Step 5: Bottom Door Guide: Slide Door to corner. Hang Door

Guide (108) on bottom of the Door. Make it flush with

Corner Flashing. Lift up approximately 3mm so that the

Door will Slide freely. Pre-drill hole and nail in place

using a 50mm nail. Slide to centre. Ensuring Door

slides freely, pre-drill hole and nail Door Guide in place.

Check Door is not binding in the middle then pre-drill

holes into each Rib at similar spacing into Door Step

Flashing. Nail off using 50mm nails.

Note:

For sheds with Raised Base Plate option the Door Step

Flashing will protrude down past the Bottom Plate. At-

tach Door Guide with rivets.

MK1A DOOR

Step 2: Hang door in Door Track. At the right hand end of

Step 4: Clean out ALL drill filings. Also make sure the

MK1A DOOR

DOOR

Door Track, adjust up or down so that the Door

hangs parallel with shed. Fit one rivet at right hand

end to hold in place. Repeat with left hand end of

track.

Nut

Washer

Aluminium

Door Stop

Wheels are cleaned of drill filings. Re-hang Door,

then insert door stops into the pre drilled holes at

end of tracks as shown in diagram. Tighten with

two spanners.

CLADDING

BOTTOM

PLATE

DOOR

GUIDE

Door Track

Washer

Bolt