Duratuf KIWI MK1A Manual de instrucciones de montaje - Página 5

Navegue en línea o descargue pdf Manual de instrucciones de montaje para Almacenamiento exterior Duratuf KIWI MK1A. Duratuf KIWI MK1A 16 páginas.

Note:

For sheds with the Raised Floor Modification option the studs will be 1.780m long to allow the Wall Sheets to pro-

trude 20mm below the Bottom Plate. Refer to Raised Floor Modification section (Page 15).

Note:

If fitting a window in the Gable end, there will be no centre stud on that side. Instead nail in a full length Nog

(2.455) using Window Studs (.883) to get correct height. Position one Window Stud centrally beneath the Nog

and nail in place. Further window studs and Nogs are fitted after the cladding is on.

Step 1: Back Wall: Select one 1.715m Base Plate (Green),

one 1.715m Top Plate (Red) and two Studs (Yellow).

Lay out Plates and two Studs on a flat surface and

nail together using two 75mm nails per join. Position

1.625m Nog .883m down from Top Plate and nail in

place.

Step 2: Front Wall: Select one 1.715m Base Plate

(Green), one 1.715m Top Plate (Red), three Studs

(Yellow) and a .785m Nog. Nail studs to each end of

Plates. Nail in remaining stud using .785m Nogs to

get correct position. Position Nog .883m down from

Top plate and nail in place.

Step 3: Select two 2.545m Base Plates (Green) and two

2.545m Top Plates (Red). With front wall lying on the

ground, nail Plates to frame. Ensure Green joins to

Green and Red joins to Red.

Step 4: Position the back wall frame on top of plates. While

someone supports frame, nail in place. Nail in centre

Stud using 1.205m End Wall Nogs to get correct po-

sition.

Step 5: Carefully roll frame over onto its base. (Pieces of

timber from the packaging may be used to temporari-

ly brace the frame before rolling it over). Position

1.205m End Wall Nogs .883m from Top Plate and

nail in place. If fitting a Kiwi Floor, fit Floor Joists

now. Space joists equally and nail in place using

three 75mm nails per end.

Step 6: Position a Jack Stud centrally on 2.545m End Wall

Top Plates and skew nail in place with two 75mm

nails per Jack Stud. Position Ridge Beam centrally

on Jack Studs and skew nail in place using two

75mm nails each end. Pre-drilling holes before nail-

ing will prevent timber from splitting.

MK1A TIMBER FRAME