Duratuf KIWI SHEDS MK2 Manual de instrucciones de montaje - Página 10
Navegue en línea o descargue pdf Manual de instrucciones de montaje para Refugios Duratuf KIWI SHEDS MK2. Duratuf KIWI SHEDS MK2 16 páginas. Base size 2545mm x 1715mm
Imprimir página
Step 1: Position the Door Track (107) on the front wall with the top
of the track 7mm below the top of the timber frame. The
end of the door track should be 20mm in from
outside of the right-hand corner flashing.
Pre-drill a hole in the centre of the track and screw in place
using one 45mm door track screw. Remove ALL drill filings
Note: Ensure Door Track screws are screwed in horizontal and
screwed hard into flashing. Protruding screw heads
can cause door rollers to bind on the screw heads.
Step 2: Hang the door in the Door Track. At the right hand end of
Door Track, adjust up or down so that the Door hangs
parallel with shed. Fit one rivet at right hand end to hold in
place. Repeat with left hand end of track.
Note: Only use rivets at each end of track.
Step 3: Remove the Door. Pre-drill and screw another 2 screws
between the centre screw and the rivets at each end
(5 screws per track). Screw track using 45mm door track
screws.
Step 4: Clean out ALL drill filings. Also make sure the Wheels are
cleaned of drill filings. Re-hang Door.
Door Stops: Predrill a hole in right-hand end of track,45mm
in from outside edge of Corner Flashing.
Predrill hole in left-hand end of track, 45mm from outside of
door jamb. (60mm for Security door option.)
Screw door stops in using 1 x Roofing screw per stop.
Check door doesn't protrude past outside edge of shed.
Step 5: Bottom Door Guide: Slide the Door to the corner of the shed.
Place the Door Guide (108) over the Guide Brackets on the
door and align the end of the Door Guide 20mm in from outside
of the right-hand corner flashing.
Step 6: Lift the door guide up approximately 3mm so that the Door will
Slide freely. Pre-drill a hole through the door guide and the end
rib of the cladding and screw in place using a 45mm screw.
Step7:
Slide the door to the centre, ensuring that it slides freely. Pre-
drill and insert a screw in the other end of the Door Guide.
Check that the Door is not binding in the middle then pre-drill
and fix with 3 more screws, one in the centre of the guide and
the other 2 evenly spaced between (5 screws per guide) into
the door step flashing and rib.
Note:
For sheds with Raised Base Plate option the Door Step Flash-
ing will protrude down past the Bottom Plate.
Attach Door Guide with rivets.
MK2 DOOR
MK2 DOOR
12
10
20mm
CLADDING
DOOR
BOT-
PLATE
GUIDE BRACKET
DOOR
GUIDE
7mm