DuraVent PolyPro Flex Series Manual de instrucciones de instalación - Página 5

Navegue en línea o descargue pdf Manual de instrucciones de instalación para Ventilador DuraVent PolyPro Flex Series. DuraVent PolyPro Flex Series 12 páginas. Polypro double-wall flex gas vent system for category ii & iv gas-burning appliances

Imprimir página

rather the top down.

•

Always use soapy water to lubricate

gaskets prior to joint assembly. Do

not use Petroleum based lubricants!

•

Plastic venting systems shall not pass

through rated fire separations.

ADDITIONAL INSTRUCTIONS FOR

TERMINATION

Duravent's PP Flex terminations are

specifically designed for use with high-

efficiency appliances that are known to

produce high volumes of fluid due to

condensation of moisture within flue gases.

DO NOT modify these terminations.

IMPORTANT: Unless the appliance is designed

to address flow of condensates from the

vent system, a drain must be incorporated

within the vent to allow condensates and

rainwater to escape. This drain must include

a trap to prevent combustion gases from

entering living spaces. Be sure to check

the appliance manufacturer's installation

instructions closely in regards to condensate

management.

INSTALLATION OF FLEX GASKET:

PP FLEX PIPE

PP FLEX GASKET

FLEX ADAPTER

FLEX TO CORRECT

LENGTH, CLEAN EDGE

INSTALL GASKET, USE

SOAPY WATER

Figure 2, Installing Gasket / Flex Adapter

PP Flex pipe must always have gaskets

installed on both ends of any installation.

Gaskets are installed on the flex pipe, with the

gasket seating inside the flex pipe grooves

(Fig.1). Use soapy water to assist installation.

1. Cut PP flex pipe (knife, saw, etc) to

desired length. Special care should be taken

to ensure cut is square, and the edge is

deburred.

2. Place Flex Gasket over Flex pipe and install

in the first whole groove nearest the end.

3. Open the locking tabs (x2) of the

appropriate flex fitting to accept the flex pipe

(Fig.2)

4. Apply soapy water to the gasket, and push

pipe/gasket into appropriate flex fitting,

seating pipe down until it bottoms out

(Fig.2).

Figure 1, Mounting the Gasket

INSERT INTO

ADAPTER

GASKET IN

FIRST

GROOVE

(CLICK!)

LOCK PIPE TO

ADAPTER