DuraVent FasNSeal W2 Manual de instrucciones de instalación - Página 5

Navegue en línea o descargue pdf Manual de instrucciones de instalación para Campana de ventilación DuraVent FasNSeal W2. DuraVent FasNSeal W2 12 páginas. Double-wall vent for category ii, ii, iv appliances

Imprimir página

appliances are designed for multiple venting.

Cat. II, III or IV appliances may not be common

vented with Cat. I, natural draft appliances.

• FasNSeal W2 must not come in contact with

plumbing or electrical systems.

• Maintain rated clearances to combustibles

over the entire length of the vent system.

• except for installation in one or two family

dwellings, a vent system that extends through

any zone above that on which the connected

appliance is located, shall be provided with

an enclosure having a fire resistance rating

equal to or greater than that of the floor or roof

assemblies through which it passes.

• Never install FasNSeal W2 on an appliance

that is not listed for use with a Special Gas

Vent or type BH vent.

• FasNSeal W2 shall not be routed into,

through, or within any vent, such as an existing

masonry or factory-built chimney, that is

connected to another appliance.

• Do not install insulation in any required

clearance space around FasNSeal W2.

Note: Follow appliance manufacturer's

allowances for elbows.

VENT SIZE AND LENGTH

Refer to the appliance manufacturer's

installation instructions for proper size and

vent configuration. Follow any horizontal/

vertical length and height limitations, minimum

clearances (air space) to combustibles, or

specifications for the use of elbows, tees, or

Drain tees.

FASNSEAL W2 ADJUSTABLE

VENT LENGTH

the W2-aVL adjustable Vent Length is

available in all diameters and allows the

installer to easily adjust the vertical or

18.00"

Overall

Length

(1)

horizontal length of a vent system. Cutting, or

piecing together several vent lengths can be

avoided.

the W2-Wt Wall thimble already incorporates

the W2-aVL. In most system layouts, this

provides enough adjustability for the horizontal

vent run.

Use the W2-aVL vertically for easy adjustment

of the required minimum 1/4" per foot pitch.

technical details about the stand alone W2-aVL:

the overall length of all FSaVL adjustable Vent

Length is 18" (1).

W2- AVL

12.00"

Adjustability

(4)

W2 Vent

Length

2.00"

(2)

4.00"

Penetration

(3)