DuraVent DCL Manual - Página 16
Navegue en línea o descargue pdf Manual para Ventilación DuraVent DCL. DuraVent DCL 20 páginas. Ul 1978 - grease duct professional series kitchen ventilation
Imprimir páginaECCENTRIC TAPERED INCREASER (ETIN)
Used when a pipe diameter change and a flat bottom on
horizontal runs is required.
Figure 41: Eccentric Tapered Increaser
ROUND FLANGED HOOD ADAPTER (RFHA)
Used to connect the first duct section to the hood. Can be field
welded or supplied to the HOOD manufacturer for installation
(by others)
Figure 42: Round Flanged Hood Adapter
SQUARE TO ROUND ADAPTER – CUSTOM PART
Used to connect a round duct to a hood with a
square/rectangular collar or to connect to a square duct.
STR's are a custom component and all requests need to go
through the DuraVent Design Group at [email protected].
Figure 43: Square to Round Adapter
ECCENTRIC SQUARE TO ROUND ADAPTER – CUSTOM
PART
Used to connect a round duct to a hood with a
square/rectangular collar or to connect to a square duct.
ESTR's are a custom component and all requests need to go
through the DuraVent Design Group at [email protected].
Figure 44: Eccentric Square to Round Adapter
CIXPRO SERIES FOR GREASE DUCT UL1978 SUBMITTAL RECORD
SECTION F – SUPPORTS
Refer to Table 5 for MAXIMUM HEIGHT / SPACING
HALF ANGLE RING (HAR)
Used for supporting and guiding the duct in horizontal runs.
Hardware by others.
Figure 45: Half Angle Ring
FULL ANGLE RING (FAR)
Used for guiding on a vertical run and allows movement for
thermal expansion.
Figure 46: Full Angle Ring
LENGTH ANCHOR PLATEE (APL)
Used for supporting the duct in vertical or horizontal runs and
to provide a fixed point for thermal expansion consideration.
Must not be in contact with combustible material.
Figure 47: Length Anchor Plate
ANCHOR PLATEE (AP)
Used for supporting the duct in vertical or horizontal runs and
to provide a fixed point for thermal expansion consideration.
Must not be in contact with combustible material.
Figure 48: Anchor Plate
REV: 0
AUGUST 2017
16
16