APlusLift HW-10KOH Manual de instalación y funcionamiento - Página 17
Navegue en línea o descargue pdf Manual de instalación y funcionamiento para Sistemas de elevación APlusLift HW-10KOH. APlusLift HW-10KOH 20 páginas. 2-post over head car lift 10,000lb capacity
También para APlusLift HW-10KOH: Manual de instalación e instrucciones de uso (17 páginas)
Imprimir página
◦ Always lift vehicle using all four pads.
◦ Never use lift to raise one end or side of vehicle.
◦ Always raise vehicle about 3" and check stability by rocking vehicle.
◦ Prior to lowering vehicle, walk around the lift and check for any objects that might
interfere with the operation of the lift and safety latches; tools, air hoses, shop
equipment.
◦ Always lower lift to the lock position before going under vehicle.
◦ Never allow anyone to go under the lift when raising or lowering.
The following periodic maintenance schedule is the minimum requirements at the minimum
intervals. Periodic maintenance is to be performed on a daily, weekly, and yearly basis.
WARNING!! OSHA AND ANSI REQUIRE USERS TO INSPECT LIFTING EQUIPMENT AT
THE START OF EVERY SHIFT. THESE AND OTHER PERIODIC INSPECTIONS ARE
USER'S RESPONSIBILITY.
FAILURE TO HEED THIS WARNING CAN RESULT IN PROPERTY DAMAGE, SERIOUS
INJURY, OR DEATH. IF YOU HEAR A NOISE NOT ASSOCIATED WITH NORMAL LIFT
OPERATION OR IF THERE IS ANY INDICATIONS OF IMPENDING LIFT FAILURE, CEASE
OPERATION IMMEDIATELY! INPECT, CORRECT, AND/OR REPLACE PARTS AS NEEDED.
Daily Pre-Operation Check (8-Hours)
1. Check safety lock audibly and visually while in operation
2. Check safety latches for free movement and full engagement with rack.
3. Check hydraulic connections, and hoses for leakage.
4. Check chain connections - bends, cracks-and loose links.
5. Check cable connections- bends, cracks-and looseness.
6. Check for frayed cables in both raised and lowered position.
7. Check snap rings at all rollers and sheaves.
8. Check bolts, nuts, and screws and tighten if needed.
9. Check wiring & switches for damage.
10. Keep base plate free of dirt, grease or any other corrosive substances.
11. Check floor for stress cracks near anchor bolts.
12. Check swing arm restraints.
Weekly Maintenance (every 40-Hours)
1. Check anchor bolts torque to 125 ft/lbs for the 3/4 inch anchor bolts. Do not use an
impact wrench to tighten anchor bolts.
2. Check floor for stress cracks near anchor bolts.
3. Check hydraulic oil level.
4. Check and tighten bolts, nuts, and screws.
5. Check cylinder pulley assembly for free movement or excessive wear on cylinder yoke
or pulley pin.
Maintenance
17