APlusLift MT1500X Manual de instalación e instrucciones de uso - Página 10
Navegue en línea o descargue pdf Manual de instalación e instrucciones de uso para Sistemas de elevación APlusLift MT1500X. APlusLift MT1500X 20 páginas. Motorcycle lift
Imprimir página
Sa fe t y Wa rnings
3 .
The warnings, precautions, and instructions discussed in this manual cannot cover all
possible conditions and situations that may occur. The operator must understand that
common sense and caution are factors which cannot be built into this product, but must
be supplied by the operator.
Improper installation or operation can cause injury or damage!
1. Read this installation and operation manual in its entirety before attempting to install
the lift. Manufacturer or distributor assumes no responsibility for loss or damage of any kind,
expressed or implied, resulting from improper installation or use of this lift. Always use an
authorized APlusLift professional installer.
2. All persons using this equipment must be responsible, qualified, and carefully follow the
operation and safety guidelines contained in this manual.
3. A level floor is required for proper lift installation and operation. The leveling pipe must be
installed through the main front roller assembly for proper lift operation as well.
4. DO NOT install this lift on any asphalt surface. Only on concrete surface a minimum of 4"
thick and 3,000 psi tensile strength with steel or fiber mesh reinforcement.
5. DO NOT install this lift over concrete expansion joints or cracks. (Check with your building
contractor or architect.)
6. DO NOT install this lift on an upper floor without written authorization from your building
contractor or architect. Should only be installed on the first floor without a basement.
7. DO NOT attempt to lift only a portion of a vehicle. This lift is intended to simultaneously raise
the entire body of the vehicle only.
8. NEVER lift any persons or equipment containing persons. This lift is designed to lift
empty equipment only.
9. ALWAyS roll equipment up the ramp on the center part of the table. Roll equipment
onto the table lifting surface in line with the front wheel clamping vise. This lift is designed to
only be center-loaded. Note that loading in the center of the table may cause serious
bending and metal failure to the frame and support rods of the table. LOAD ONLy ON THE
CENTER LINE. Please see the center line in drawing on page 5 for reference.
Copyright
2020
C
ONLY AFTER CAREFULLY READING ALL OF THE
PRECEDING SAFETY WARNINGS SHOULD YOU ATTEMPT
TO INSTALL OR OPERATE THIS LIFT!
TM
Phone: 800-616-9618 Text: 425-300-2600 Email: [email protected]
www.apluslift.com
APlusLift MT1500 & MT1500X
I N ST ALLAT I ON M a nua l
10 of 20