APlusLift HW-10KBP Manual de instalación y funcionamiento - Página 13

Navegue en línea o descargue pdf Manual de instalación y funcionamiento para Columnas elevadoras APlusLift HW-10KBP. APlusLift HW-10KBP 20 páginas. 2-post floor plate car lift 10,000lb capacity
También para APlusLift HW-10KBP: Manual de instalación e instrucciones de uso (16 páginas), Manual de instalación y funcionamiento (20 páginas)

Imprimir página

APlusLift HW-10KBP Manual de instalación y funcionamiento

Step 8 (Final Setup)

Mount The Floor Plate Cover

 Mount the floor plate cover tight with socket head cap screws.

Check Assembly

 Check all bolts and nuts to make sure they are tight. Do not use an impact gun on

concrete Anchors.

 Check all fittings or leaks. If necessary, make sure the arm lock restraints are engaging

properly and smoothly. If not, tap the main lock forward or backward as needed with a

rubber mallet to insure proper engagement on all 4 gears with the arm restraint locks.

 Cycle lift up and down to insure carriages are synchronized.

Screw-In Pads and Truck Adapters

 Before lifting a vehicle, please adjust the height of screw-in pads

to fit.

 Use truck adapters if needed. Please remove the snap rings from

the screw-in pads before using the pads with truck adapters.

 Never exceed 9" of pad height.

Toe Guards and Tool Trays

 Toe guards and tool trays may be installed on the side of 2-stage

arms. Please check the picture on the right.

Test & Adjust Lift

 With the power properly hooked up and hydraulic oil in the pump reservoir, push the

push button on the side of the Motor to raise the carriages off the locks. Release the

push button and then pull the lock release cable under each carriage to release the

locks. Run the lift all the way up and down two more times to bleed all the air from the

system.

 While running the lift, listen to safeties clicking. Each side should click simultaneously

or with-in a 1/2 second of each other. If they are not clicking together, then adjust the

cables to compensate by tightening the side opposite the one that is clicking last at the

cable bolt at the top of the carriage on the same side.

 Remember not to over tighten cables – they should be firm, much like a banjo string or

a fan belt in a car.

Bleed Air from Cylinders

 Place a vehicle on the lift and raise until swivel pads are in contact with the frame of

the vehicle. Raise the vehicle about 3 feet and then lower the vehicle until the tires

touch the floor. Keep raising and lowering the vehicle a few times and increase the

height each time until the vehicle completely reaches to the top. This procedure pumps

all the air from the system.

 Lifting speed will be faster (be normal speed) after air is bled out.

Please Check

https://www.apluslift.com/pages/faq

Please Check Operation, Safety, and Maintenance Before Use.

for Troubleshooting.