Apogee 10545 Manual de instrucciones - Página 5
Navegue en línea o descargue pdf Manual de instrucciones para Juguete Apogee 10545. Apogee 10545 8 páginas. 1.9" ebay kit for aerotech rockets
Imprimir páginaSled Assembly Continued...
14. Once your corresponding holes are
determined, carefully remove the laser cut holes
on the sled with a small screwdriver or pencil.
Feel free to rub a small amount of wood glue
into the remaining holes that won't be used to
seal them.
15. Use your 4-40 tap and drill kit to hand
thread the open holes for your altimeter place-
ment.
16. Flip the sled over and tape the Li-Po
battery to the bottom of the sled. *When setting
the tape in place, try to avoid the holes that you
need for the altimeter placement.
17. Remove 4 of the wooden washers Part
"D" from the plywood sheet. The remainder can
be saved and used later if needed. They are
provided as extras. *Refer to the "Step 4 Image"
on Page 3 for help locating these.
18. Flip the sled back over to the top side,
and carefully place the 4 small wooden wash-
ers over the corresponding holes. Then slowly
place the altimeter on top of your wooden
washers.
19. Use your screwdriver to insert the small
plastic screws Part "J" into the corner holes on
the top of the altimeter and into the threaded
holes in the sled assembly. You may need to
carefully adjust the washer placement as they
can slide around while you insert the screws.
NOTE: The screws will not extend from the
bottom side of the sled
20. Attach the switch wiring to the altimeter
(per your altimeter instructions).
21. Connect the battery to the altimeter (refer
to altimeter instructions for details).
Step 14
Bottom of Sled
Tape Battery
Side View
Top View
Screw Placement
E2 Side
Altimeter
Wooden Washers
Switch Connection
Steps 19-20
Step 15
Step 16
Step 18
Page 5