Apogee DDX-2060 Manual - Página 12
Navegue en línea o descargue pdf Manual para Amplificador Apogee DDX-2060. Apogee DDX-2060 13 páginas. All-digital high efficiency power amplifier
DDX-2050
INRA = INRB and outputs combined OUTLA =
OUTLB, OUTRA = OUTRB.
ADDITIONAL INFORMATION
Output Filter
A passive two-pole low pass filter is used on the
DDX-2050 power outputs to reconstruct an
analog signal.
System performance can be
significantly affected by the output filter design
and choice of components. A filter design for
8Ω loads is shown in the Typical Application
Circuit in Figure 4.
Power Dissipation/Heat Sink Requirements
The power dissipation of the device will depend
primarily
on
the
supply
voltage,
load
impedance, and output modulation level.
The
DDX-2050
surface
mount
package
includes an exposed thermal pad on the bottom
of the device to provide a direct thermal path
from the integrated circuit to the PCB. This pad
must be soldered to a low thermal impedance
path at circuit ground potential for proper
operation, e.g.
a PCB ground plane.
For
continuous duty rated applications, careful
consideration must be made to the overall
thermal design.
For additional thermal design considerations,
see
http://www.apogeeddx.com/DDX_Themal_Cons
iderations.PDF
PRELIMINARY
Specifications are subject to change without notice.
PRELIMINARY
129 Morgan Drive, Norwood, MA 02062
voice: (781) 551-9450
fax: (781) 440-9528
email: [email protected]
CONTROLLED DOCUMENT: P_903-000030_Rev00 Data Sheet, DDX-2050.doc DRN: PRELIMINARY
Page 12 of 13