Apollo 51000-601 Manual de instalación - Página 9

Navegue en línea o descargue pdf Manual de instalación para Alarma de humo Apollo 51000-601. Apollo 51000-601 15 páginas. Wireless combination smoke, heat and carbon monoxide detector

Imprimir página

Alignment

marks

Figure 15 - Detector fully aligned and installed on mounting base

Figure 13 - Installing the base

8. TAMPER PROTECTION

Alignment

The Wireless Combination Smoke, Heat and Carbon Monoxide Detector has a built-

marks

in tamper switch which will cause a tamper signal to be transmitted to the control

panel if the detector is removed from the mounting base. The detector also

includes an anti-tamper feature which prevents the detector being removed from

the mounting base. To enable the anti-tamper feature cut the anti-tamper tab on

the mounting base (Figure 16 and Figure 17) and install the detector on the

mounting base. When the anti-tamper feature has been enabled, to remove the

detector from the mounting base, a small screwdriver must be inserted in the anti-

tamper release hole (Figure 18) to press on the release lever whilst turning the

detector counterclockwise.

Figure 14 - Detector aligned to base prior to completing installation