Apollo REACH WIRELESS RW1900-901APO Manual de inicio rápido - Página 2

Navegue en línea o descargue pdf Manual de inicio rápido para Sistema de seguridad Apollo REACH WIRELESS RW1900-901APO. Apollo REACH WIRELESS RW1900-901APO 2 páginas. Manual call point

Imprimir página

Operating Principles

The RW1900-901APO REACH Wireless Manual Call Point is a

wall-mounted device that, when activated, initiates an alarm

on the fire security system. After its use the call point unit can

be simply reset with its proper key, making it immediately

ready for reactivation.

Status LED

When one or more faults are present in the system they are

shown on the LCD and the fault LED is switched on yellow.

LCD is ON only when the tamper switch is not activated

(cover open) regardless of the configuration of the translator

tamper fault. See table 1 for LED status meanings.

Table 1: REACH Wireless Device Status & LED

Indication

Device Status

Power Up

Power Up (dip-switch ON)

Blinks alternatively green/red four

Entering Wake-Up

Link Success

Enters wake-up mode and signals

Link Failure

'Entering wake-up mode' following

Normal Condition

Activation

Battery Faults

Tamper Fault

Replaced

Device Addressing

Device addressing is handled by the REACH Wireless Loop-

Interface device (RW1700-030APO.

Devices are soft-addressed automatically when pairing with

the Loop Interface and can be changed manually. Hard-

addressing using Apollo XPERT cards are not supported.

Communication

REACH Wireless Devices use 'radio-frequency' wireless

communication to connect to the Loop-Interface.

The Loop-Interface (RW1700-030APO) translates the wireless

communication into wired Apollo protocol communication,

with each device addressable individually by the fire panel.

See datasheets for the Loop-Interface for more information.

Tamper detection

REACH Wireless devices contain an anti-tamper mechanism.

In the event of removal from its base, it sends a tamper

detection message to the Loop-Interface.

Tampering detection is not signalled visually by the device

LED.

LED Indication

Blinks green four times

Blinks red four times

times

Blinks green four times, then

repeats

this failure

LED off

Red on 1s, period 2s

LED off

Blinks amber two times

EMC Directive 2014/30/EU

REACH Wireless Manual Call Point complies with the

essential requirements of the EMC Directive 2014/30/EU,

provided that it is used as described in this datasheet.

A copy of the Declaration of Conformity is available from

Apollo on request.

Construction Products Regulation (EU) 305/2011

The REACH Wireless Manual Call Point complies with

the essential requirements of the Construction Products

Regulation (EU) 305/2011

A copy of the Declaration of Performance is available from

Apollo on request.

PP5115/2022/Issue 1

Page 2 of 2