Apollo Sprayers E7000 Manual de instrucciones - Página 4

Navegue en línea o descargue pdf Manual de instrucciones para Pulverizador de pintura Apollo Sprayers E7000. Apollo Sprayers E7000 10 páginas.

Conventional Spray Systems

Conventional spray systems:

12-20 PSI @ 8 CFM

30-50% transfer efficiency

- Excessive, costly Solution waste

- Unhealthy for operator and

harmful to the environment

E7000 spray gun offers you many options. You can turn the air cap ( #1-2) to two positions. One will produce a horizontal

pattern for spraying across, another will produce a vertical pattern for spraying up and down.

PREPARING TO USE YOUR ECO SPRAY SYSTEM

Connect the air hose to the Turbine, pull back the spring-loaded quick disconnect coupler and insert the male connector

on the air hose into the turbine connector. Release the ring. Your air hose will be locked into place. To disconnect, pull

back on the connector to release the air hose. CAUTION: If you have just finished spraying, the metal coupler at the

turbine end may be hot.

Plug the electric cord into a correctly grounded electrical outlet. Be sure the electric current is the correct voltage. If you

need to use an extension cord, be sure it is at least 12-gauge wire and has a correctly grounded outlet. (240v units for use

outside of the United States are often only supplied with an electric cord. A correct plug must be installed prior to use.

Make sure the ground wire is properly connected).

Select a safe, well-ventilated area where you will spray your client. Locate your Turbine unit away from the area where

you will be directly spraying.

FAMILIARIZING YOURSELF WITH YOUR APOLLO E7000 SPRAY GUN

Familiarize yourself with the controls on the spray gun. There are three principal controls: The rotating air cap (#1-2); the

Material Adjustment Screw (#21); and the Fan Pattern Adjustment Knob (#11). Loosen the Air Cap Ring (#1-1) slightly to

turn the rotating air cap to each position, Horizontal and Vertical. The horizontal position will give you a vertical fan

pattern. The vertical position will give you a horizontal fan pattern.

The Fan Pattern Adjustment Knob (#11) will allow you to achieve the round pattern. To obtain the round pattern turn the

knob so that it is in the horizontal position. When the knob is in the horizontal position the spray gun will only give you a

round pattern. This is useful for spraying small, narrow areas or touching up a small area. When the knob is in the vertical

position you will only get a fan pattern.

NOTE: It is sometimes necessary to lubricate the end of the air adjusting knob with some lithium grease. Do not use too

much or it may contaminate your air supply. Remove the screw on the top of the spray head and pull the air adjusting

knob out. At the very end of the shaft put some lubricant on the outer surface. This will help it slide smoothly when

twisted back and forth inside the spray head.

Next, turn the Material Adjustment Screw (#21) anti- or counter-clockwise to open or release more fluid, clockwise to

reduce or close material flow. NOTE: If you are using the round fan pattern it is usually necessary to reduce the amount

of fluid.

Bounce Back Comparisons

Apollo ECO TrueHVLP™ Spray System

TrueHVLP™ Spray System

7.0 PSI @ 85 CFM

- Up to 90% transfer efficiency

Substantial Solution savings

Cleaner and safer for both

operator and environment