AddSecure IRIS-4 160 Manual rápido de instalación y mantenimiento - Página 7

Navegue en línea o descargue pdf Manual rápido de instalación y mantenimiento para Sistema de seguridad AddSecure IRIS-4 160. AddSecure IRIS-4 160 11 páginas.

Imprimir página

IRIS-4 160

Quick Installation and

Maintenance Guide

IRIS-4 160 using 4g/3g/2g connection:

4G/3G/2G Network Scan

Select the '4G/3G/2G network scan' .

The scan must be carried out without the SIM card

fitted . The dialler listens for every base station in

range, requests operator name and records the signal

strength . This will take a few minutes to complete .

This will take a few minutes to complete.

For a reliable 4G/3G/2G connection it is recom-

mended that for the chosen network (SIM card) used

there should be at least two base stations with signal

strength (CSQ ) of 10 or more .

If the signal strength is below or close to minimum

then try to reposition the IRIS-4 160 or use an exter-

nal building or high gain antenna (if necessary), and

rerun the network scan to check signal strength .

Once you have the required 4G/3G/2G signal

strength power down the dialler and insert the SIM

card into the SIM card holder .

Insert the 4 x AA batteries if required

and power the dialler back up.

Now press the button labelled AP again and on the

connection device connect to the 'IRIS' network and

using the web browser connect to the IRIS-4 160 web

interface again by browsing to 'iris . l ocal' .

Enter in the installer code setup beforehand and then

select the Installation Wizard as indicated next .

IRIS-4 160 not using 4g/3g/2g or using

ethernet/Wi-Fi after network scan completed:

Installation Wizard

Select the Installation Wizard and follow the on

screen prompts .

Note 1: If installing the IRIS-4 160 without batteries

then please untick the 'Use battery backup' option.

Note 2: During the Installation Wizard the Wi-Fi

status screen and the signal strength will be

displayed. For a reliable Wi-Fi connection it is

recommended that the Wi-Fi network used should

have a signal strength of 20 or more. If this signal

strength is lower than suggested try moving the

IRIS-4 160 nearer the Wi-Fi router.

Once Installation Wizard is completed and any

additional panel interface configuration setup via

the settings menu, check/configure the panel for

the connection method being used and the current

battery status .

IRIS-4 160

To check the current battery status go to the option

'Battery status' in the main menu and this will indi-

cate the current status of the batteries .

Please go into the 'Battery status' option and confirm

that the Health status is showing as "Good" before

leaving site, as shown: