Acer AT2326 Manual del usuario - Página 30

Navegue en línea o descargue pdf Manual del usuario para TV LCD Acer AT2326. Acer AT2326 39 páginas.
También para Acer AT2326: Manual rápido (2 páginas)

Imprimir página

Channel management

Open the Channel Management menu as described in the OSD navigation section. This

menu provides the following settings:

Auto scan

Auto scan allows you to scan for new or deleted channels. If you completed the setup

wizard the first time you turned on your TV, all available channels are listed.

To scan again, select the Auto Scan setting, and then your country from the Country List.

Use the directional keys to select Start and press the OK key.

Wait until the scan has finished; this will take several minutes.

Time zone

If there are multiple time zones in the country selection, set your local time zone here. In

countries with only one time zone this will be set automatically.

Manual scan

Digital manual scan

You can manually add a digital channel by searching in specific UHF channels. Use the left

or right directional keys to change the channel being scanned.

Analog manual scan

You can manually add an analog channel by adjusting the settings here. Use the up or

down directional kays to select a setting to change, use the left or right directional keys

to change the setting. You may set: the analog channel where the signal will be stored,

the encoding system, which direction to search through analog frequencies, fine tune to

a specific frequency and if this channel will be skipped in the channel list.

Use the left or right directional keys to change the channel being scanned.

Channel edit

You can edit the detected channels, to change how they are displayed in the channel list.

Use the up or down directional keys to select a channel, you may then use the coloured

keys to perform different actions:

Delete (red): You can remove a channel from the Channel List. Press the red key once

to mark a channel for deletion, then press the red key again. Finally select Yes and

press the OK key to remove the channel. Press the BACK or MENU key to cancel.

Rename (green): You can rename an analog channel (not digital channel as the

names are assigned by the broadcaster). Press the green key, then use the left or right

directional keys to select the character to change, then use the up or down directional

keys to change the letter. Names are limited to 5 characters. Press the green key to

confirm or Menu to cancel.

Move (yellow): Press the yellow key, then use the up or down directional keys to

move the channel up or down through the channel list. Press OK to confirm or Menu

to cancel.

Skip (blue): Press the blue key to select channels you want to skip. These channels

will automatically be skipped when the OK key is used to select channels later on.

However, you can still manually select these channels.