Durite 0-441-10 Manual de inicio rápido
Navegue en línea o descargue pdf Manual de inicio rápido para Equipos de iluminación Durite 0-441-10. Durite 0-441-10 4 páginas. Led high intensity warning light x 2 on mounting plate
Imprimir páginaLED High Intensity Warning Light x 2 on Mounting Plate
Before using this unit please read these instructions carefully. Take special care to follow
the warnings and safety suggestions listed below. Keep these instructions for future refer-
ence.
1. Proper installation of this product requires the installer to have a good understanding of
automotive electronics, systems and procedures.
2. If mounting this product requires drilling holes, the installer MUST be sure that no vehi-
cle components or other vital parts could be damaged by the drilling process. Check both
sides of the mounting surface before drilling begins. Also de-burr the holes and remove any
metal shards or remnants.
3. Do not install this product or route any wires in the deployment area of your air bag.
Equipment mounted or located in the air bag deployment area will damage or reduce the
effectiveness of the air bag, or become a projectile that could cause serious personal injury
or death. Refer to your vehicle owner's manual for the air bag deployment area. The User/
Installer assumes full responsibility to determine proper mounting location, based on pro-
viding ultimate safety to all passengers inside the vehicle.
4. Do not attempt to activate or control this device in a hazardous driving situation.
5. This product contains either strobe light(s), halogen light(s), high-intensity LEDs or a
combination of these lights. Do not stare directly into these lights. Momentary blindness
and/or eye damage could result.
6. All connections must use waterproof connectors and any unconnected wires must be
sealed to prevent water ingress via the wire core, failure to do this may result in premature
failure and invalidate the warranty.
Part 0-441-10
WARNINGS
SAFETY WARNING
www.durite.co.uk
0-441-10-LEAF