DURKOPP ADLER 867 Manual de instrucciones - Página 7
Navegue en línea o descargue pdf Manual de instrucciones para Accesorios para máquinas de coser DURKOPP ADLER 867. DURKOPP ADLER 867 8 páginas. Remaining thread monitor
También para DURKOPP ADLER 867: Manual de instrucciones (16 páginas), Instrucciones (4 páginas), Manual de instrucciones (16 páginas), Instrucciones adicionales (18 páginas), Instrucciones adicionales (20 páginas)
Klasse 867 Anbauanleitung Nahtmittenführungen
N800 005655 (mechanisch) N800 005650 (pneumatisch)
Class 867 Instructions for fitting seam center guide
N800 005655 (mechanical) N800 005650 (pneumatically)
3.3 Completing the compressed air maintenance unit
–
Connect the pre-assembled pneumatic connection 1 and the
available maintenance unit 2 (on the strut of the stand)
and connect the pneumatic hose.
(see assembly instructions item 7 pneumatic connection).
3.4 Aligning the seam center guide
–
The guide 3 should be in central position and as close
as possible to the sewing foot so that the distance to
the left and the right needle is equal.
The distance between guide 3 and the throat plate
should amount to approx. 1 mm.
3.5 Making the electrical connection
Attention !
All operations on the electrical equipment of the special
sewing machine must only be carried out by electricians or
correspondingly trained personnel.
The mains plug has to be pulled out!
The manufacturer's operating instructions enclosed to
the sewing drive have to be observed by all means!
–
Lay the cable 6 from the solenoid valve (pre-assembled
pneumatic connection) upwards in the distributor and
connect it to the cable connector 7, X22, PIN3 (FF3 OUT)
and PIN 1, 7 or 8 (+24V) at the printed circuit board.
Ausgabe/Edition:
05. 2006
Attention!
The pressure for the seam center guide must not exceed 3 bar.
To be read off at the manometer 5 and to be set at the turning
handle 4.
Printed in Federal Republic of Germany
Teile-Nr./ Part-No.:
6
1
2
3
4
7
Blatt:
Sheet: 7
0791 867701
5
von
from 8