DataBay ET-HK0101-RC Manual del usuario - Página 7

Navegue en línea o descargue pdf Manual del usuario para Extensor DataBay ET-HK0101-RC. DataBay ET-HK0101-RC 10 páginas. Hdmi over single cat-5 extender kit with ir

Imprimir página

2. For desirable 1080p video output, please follow the instructions below:

Step 1 – Please set the rotary arrow on TX at

Step 2 – Please turn the rotary arrow clockwise [] from

Step 3 – Please turn the rotary arrow counterclockwise [ ] from

Step 4 – Please turn the rotary arrow clockwise [] from

3. To learn EDID from the HDMI display, please follow the instruction below:

Step 1 – Please connect the display which you want to read EDID with a HDMI

Step 2 – Please turn the rotary arrow clockwise [] from

ET-HK0101-TC Rear View

+5V DC:

Connect to 5V DC power supply.

HDMI Signal OUT:

Plug in a CAT-5/5e/6 LAN cable that needs to be linked to the RJ-45 connector of the

receiving unit ET-HK0101-TC.

wait for the LED of the RJ-45 connector blinks for a couple seconds.

you can get audio/video from the display, you can stay tune at this

setting for 1080p and stereo audio. If you need to get 1080p with 7.1ch

audio output, please turn the rotary arrow counterclockwise [ ] from

Mode 1

Mode

0. If you cannot get the audio/video out normally,

please go on the next step.

Mode

7. Wait a few seconds until the LED of the RJ-45 connector

dims and then lights again.

You should have your desirable audio/video output. If not, please

follow the instruction in Note#1.

cable to the transmitter's HDMI IN and set the rotary arrow at

so the TX can learn the EDID information from the connected display.

The LED on the RJ45 connector of TX will dim and light again in a few

seconds, which indicates the EDID learning procedure is complete.

Mode 1

for desirable audio setting and enjoy the experience. DO NOT

let the rotary arrow pass by

EDID just learned and restore the default EDID.

"Mode

Mode 5

and

Mode 6

7 / 10

6" for Default Mode, and

Mode 6

Mode

Mode 0/1

Mode 7

Mode

Mode 7

Mode 0

which will erase the

1. If

0/1.