Datacom Systems VS-1212-F Manual de instalación rápida - Página 9

Navegue en línea o descargue pdf Manual de instalación rápida para Interruptor Datacom Systems VS-1212-F. Datacom Systems VS-1212-F 17 páginas. 10/100/1000 mb and 10 gb data access switches

Imprimir página

Furthermore, connecting the second AC input power socket to a different external power source

circuit than the first AC input power source eliminates power as a single point of failure.

POWER 1 and POWER 2 LEDs on the front panel.

green

2.8

Rear — Management Module

The SERIAL 1 connector port is a shielded DB9 Female and is

cabled to the COM port of any compatible network tool or PC

with any terminal emulation application resides using the

Datacom Systems Command Line Interface (CLI) Software.

The SERIAL 2 connector port is reserved for future use

The MANAGEMENT connector port is a shielded RJ45 and is cabled to the network.

Media Access Control (MAC) address identifier and certification compliance identifiers are

provided on this rear label.

Network IP Address Configuration

All VS-1212-F and VS-1224-F series units are shipped with a factory default configuration as

follows:

IP Address:192.168.1.1; Subnet Mask: 255.255.0.0; Gateway: 192.168.1.0

User name: Administrator password: admin

IMPORTANT: If you expect to remotely connect to the VS-1212-F and VS-1224-F series, you

must change the IP Address, Subnet Mask and Gateway to match your Local Area Network.

Note: If your VS-1212-F and VS-1224-F already has the IP Address, Subnet Mask and Gateway

set for your network, you may proceed to the

This simplified sample initial configuration uses the SERIAL1 DB9 Female port.with the shipped

DRL512-2M-R DB9 M/F straight thru cable. Any freely available terminal emulator (PuTTy or

Tera Term for example) may be used, but please note the following specific terminal settings:

115,200 bits per second; 8 data bits; Parity none; 1 stop bit; Flow control none

Step 1. Connect your PC and your VS-1212-F or VS-1224-F using the provided Datacom

Systems DRL512-2M-R cable. Connect the DB9 Female pin end to the serial port on your PC and

connect the DB9 Male pin to the CONTROL port on your VS-1212-F or VS-1224-F.

The AC power switch is a rocker style switch. The circle icon

depressed is OFF and the bar icon depressed is ON. To

power the unit ON, depress switch bar icon. The powered ON

VS-1212-F and VS-1224-F is indicated by the illuminated

'Stand-Alone Installation

Overview

' section.