Addvent AVAC9000CM Instrucciones de instalación y manual de usuario - Página 3

Navegue en línea o descargue pdf Instrucciones de instalación y manual de usuario para Aire acondicionado Addvent AVAC9000CM. Addvent AVAC9000CM 4 páginas. With 12 hour timer

Imprimir página
AVAC9000CM[07]instructions
29/1/07
Operation

CONTROL PANEL

Power Control
The power control turns the unit on and off.
Warning Light
Condensed water may accumulate in the unit. If the internal tank becomes
full, the warning light will light up and the unit will not operate until it has
been drained.
Mode Control
The MODE control has three settings:
The settings are adjusted with the Mode Control button.
A light indicates which setting is currently being used.
Cooling Mode
When COOL mode is selected, the indicator light turns green.
In cooling mode the air is cooled and hot air is exhausted to the outside
through the exhaust tube. Adjust the fan speed and air temperature to suit
your desired comfort level.
Note : The air exchange hoses must vent outside the room when using cool mode.
Dehumidify Mode
When DEHUMIDIFY mode is selected, the indicator light turns orange. Air is
dehumidified as it passes through the unit, without being in full cooling mode
If room temperature is 25°C, the fan speed can be adjusted; otherwise the fan
speed is fixed to 'MED'.
Note : If the unit is to be used as a dehumidifier, do not connect the exhaust hose,
let the warm air return to the room.
Continuous drainage is then necessary.
14:37
Page 4
Cool
Dehumidify
Fan
G
G
G
4
Fan Mode
When FAN mode is selected the indicator light turns yellow.
Air is circulated throughout the room with no cooling.
Note: unit does not need to be vented in FAN mode
Fan Speed Control
The Fan Speed Control has 3 settings:
G
Timer
Auto turn off: With the machine running, press TIMER button to select
number of hours you would like the unit to run in air conditioning mode until
it automatically shuts off.
Auto turn on: With the machine in STAND BY mode, press TIMER button
to select the time that you would like the unit to automatically start running
in air conditioning mode.
Timer/Temp set controls
Used for adjusting the timer and thermostat.
G
The default display is current room temperature.
G
L
M
In cooling mode, use either the
or
G
temperature. After 15 seconds the display will revert back to actual room
temperature. Temperature is only adjustable in cool mode.
The time is adjustable between 1-12 hours.
Note : By pressing both Timer/Temp set buttons at the same time, the display will
toggle between Celsius and Fahrenheit.
After switching the air conditioner off, you must wait 3 minutes
before switching it back on again.
5
High,
Medium, and
Low.
G
G
to set the desired room