DataComm 70-0020 Hoja de instrucciones/instalación

Navegue en línea o descargue pdf Hoja de instrucciones/instalación para Unidad de control DataComm 70-0020. DataComm 70-0020 2 páginas. Electronics phone/video module
También para DataComm 70-0020: Hoja de instrucciones e instalación (2 páginas)

Imprimir página

DataComm Electronics Phone/Video Module 70-0020

Step 1 Video

 Attach a female F-connector onto the cable TV service or satellite service

incoming cable.

 Screw the incoming cable with F-connector to the connector marked

"input".

 Using F-connectors, terminate all coaxial leads that have been pulled

through the top knockout to the video splitter.

 Align the four mounting pins with holes in the back of the panel (upper

most position recommended) and snap into place.

Step 2 Telephone

 Pull the telephone wires into the HCC panel from one of the side

knockouts.

 Install the cable from the telephone company demarcation point to the

110 IDC marked from Telco.

 Install the twisted pair cables from each location in the house to the

remaining 110 IDC connectors. Match the color-coding of the wires to the

colors on the 110 IDC connectors.

 The wires should be punched down, using an industry standard punch-

down tool, to the 110 IDC connectors following the T568A wiring

configuration as shown below.

 Line 1 is Blue, Line 2 is Orange, Line 3 is Green and Line 4 is Brown.

 A RJ31X port is provided for line 1 seizure by security system.

INSTRUCTIONS ARE CONTINUED ON THE BACK SIDE OF THIS PAGE

Instruction / Installation Sheet

1x8 Coax 4x10 Phone Module

White / Blue

Blue

White / Orange

Orange

White / Green

Green

White / Brown

Brown

3/13/08 Rev. 1