DataComm 70-0025 Hoja de instrucciones/instalación - Página 2
Navegue en línea o descargue pdf Hoja de instrucciones/instalación para Unidad de control DataComm 70-0025. DataComm 70-0025 2 páginas. Electronics phone/video module, 1x8 video splitter and 4x16 rj45 phone module
Imprimir páginaDataComm Electronics Phone/Video Module 70-0025
1x8 Video Splitter and 4x16 RJ45 Phone Module
Step 3 Telephone
Install RJ45 plugs (purchased separately – DCE part #20-5703) on all Cat
5e wiring home runs to the HCC panel.
Be sure to wire the RJ45 plugs per the RJ45 plug instructions. Mis-wired
RJ45 plugs will create a short or no dial tone.
Once all RJ45 plugs are installed on the home runs, determine which
telephone jacks in the house will be line 1. To connect line 1, insert the
RJ45 plug on the Cat 5e home run into RJ45 ports labeled line 1 on the
telephone module. Each of these home runs will now be connected to
line 1.
To connect line 2, use same instruction as line 1 and use line 2 labeled
RJ45 ports.
To connect line 3, use same instruction as line 1 and use line 3 labeled
RJ45 port.
To connect line 4, use same instruction as line 1 and use line 4 labeled
RJ45 port.
CAUTION
Never install telephone wiring during lighting storms.
Never install telephone jacks in wet locations unless the jack is
specifically designed for wet locations.
Never touch un-insulated wires or terminals unless the telephone
line has been disconnected at the network interface.
Use caution when installing or modifying telephone lines.
IMPORTANT INSTRUCTIONS
Read and understand all instructions.
Follow all warnings and instructions marked on the product.
Do not use this product near water, for example a near bath tub,
wash bowl, kitchen sink, or laundry tub, in a wet basement, or near a
swimming pool.
SAVE THESE INSTRUCTIONS.
ONLY LICENSED PROFESSIONALS SHOULD INSTALL THIS PRODUCT
Instruction / Installation Sheet
ETL LISTED
CONFORMS TO
UL STD 1863
ANSI/UL STD 60950-1
3026001
CERTIFIED TO
CAN/CSA STD C22.2 NO 60950-1
4/1/08