Durston Tools Quad Ringer Manual de instrucciones - Página 9
Navegue en línea o descargue pdf Manual de instrucciones para Herramienta eléctrica Durston Tools Quad Ringer. Durston Tools Quad Ringer 12 páginas.
Imprimir página
The blade breaks – most likely caused by incorrect use or using worn/damaged blades
Ensure that the blade is in the centre of the coil holder lid.
Hold the handpiece holder against one side of the coil holder with both hands and do not allow it to twist
during the cut. Keep it horizontal.
Check your saw blade does not have broken teeth and replace when it is wearing out.
Use Durston/burr lube every time to prolong the life of your blade.
Check that your blade will turn in the correct direction during the cut.
The coil slides away in the coil holder and is damaged
Motor in reverse! Always check your motor is set to Forwards before use.
The coil has a double cut
Ensure that you complete the cut with one smooth action. If you stop the motor during the cut do not start
up again. Remove the coil and rings from the holder and set up the remaining part of the coil up again.
Conversion Tables
American
Wire Gauge
(AWG)
14
15
16
17
18
19
20
21
22
23
24
Calculating the length of coil required for x jump rings.
Example:
50 jump rings are needed from 1mm wire.
Make a coil 50 x 1 = 50mm plus 2 to 4mm extra
50 jump rings from 1.3mm wire.
Make a coil 50 x 1.3 = 65mm plus 3 to 6 mm extra
Using square wire
Do not allow the wire to twist when forming the coil. Hold the wire in parallel pliers and wind the coil slowly
and carefully so that the flat side of the wire is firmly against the mandrel.
Further Notes and Tips
Standard
Diameter
Wire Gauge
(mm)
(SWG)
1.63
16
1.45
17
1.29
18
1.15
19
1.02
20
0.91
21
0.81
22
0.72
23
0.65
24
0.57
25
0.51
26
Diameter
(mm)
1.626
1.422
1.219
1.016
0.914
0.813
0.711
0.61
0.559
0.508
0.457
7