DATAGRABBER RapidRH L6 with Bluetooth Manual de instrucciones - Página 4

Navegue en línea o descargue pdf Manual de instrucciones para Registradores de datos DATAGRABBER RapidRH L6 with Bluetooth. DATAGRABBER RapidRH L6 with Bluetooth 11 páginas.

Imprimir página

RAPID RH L6

CONNECT

First, make sure you have downloaded the free DataMaster

L6 app to your smart device. Open the app, and the app

will open up in the audio tutorial mode. You may wish to go

through this tutorial, but if not, just press the Skip button in

the extreme lower right-hand corner of the screen, and the

following DataMaster L6 screen will appear:

Next, click on the Menu icon located in the upper right-hand

corner of the screen. A menu will appear, choose Manage

Devices and you will be on the Devices screen. If you are in

proximity of any DataGrabber with Bluetooth units installed

in L6 sensors, the unit with the greatest signal strength will

appear as the first unit at the top, followed by any other

DataGrabber units within Bluetooth range. Now you can

begin to configure your DataGrabber units (See Configuration

section).

CONFIGURATION

Each DataGrabber with Bluetooth can be configured for

Device Name, Acclimation Time and Log Interval. From

the Devices screen, select the specific DataGrabber with

Bluetooth you wish to configure. Next, click the Settings

button. The DataGrabber is available for configuration if

the Settings button is green. However, if the Settings button

is grey, you may need to troubleshoot your device (see

Troubleshooting section). In approximately 20 seconds or

less, the Device Settings screen for that DataGrabber will

appear; see below.

WAGNER METERS