Datalogic Compact 2D Reader Matrix-2000 Manual de consulta rápida - Página 10

Navegue en línea o descargue pdf Manual de consulta rápida para Lector de códigos de barras Datalogic Compact 2D Reader Matrix-2000. Datalogic Compact 2D Reader Matrix-2000 11 páginas.

Imprimir página

Autolearning:

The Autolearning procedure makes it possible to obtain an automatic, accurate and fast configuration of

Matrix-2000™ without the necessity of directly checking/modifying the relevant parameters using VisiSet™. Valid

code symbologies for this procedure are: DataMatrix ECC 200, PDF417 standard, Code 128, Code 39,

Interleaved 2 of 5 and EAN-UPC.

To run the Matrix-2000™ Autolearning procedure follow these steps:

Position the Matrix-2000™ reader in front of the code at the correct focus distance according to your model

(refer to the Reading Features table).

Power up the Matrix-2000™ and press the keypad button positioned on top of the reader for at least 2

seconds; Matrix-2000™ will emit 3 high pitched beeps and the POS and CAL LEDs will start blinking. Slow

blinking means that positioning and calibration values must be improved.

To obtain the best value in terms of POSITIONING, move the code and/or the reader so as to position the

code as close as possible to the center of the Field of View, keeping the correct focus distance. Check POS

LED blinking: the best code positioning corresponds to fast (almost continuous) blinking. The best value in

terms of CALIBRATION will automatically be achieved by the reader by changing the settings of the

Acquisition parameters. Check CAL LED blinking: the best reader calibration corresponds to fast (almost

continuous) blinking.

The Autolearning procedure will automatically exit as soon as the best positioning and calibration are

reached. The code symbology read during this procedure will automatically be enabled. The new

configuration parameters will be stored to permanent memory. Matrix-2000™ will emit 3 high pitched beeps.

If positioning or calibration cannot be reached within 3 minutes, Matrix-2000™ will exit without saving the

configuration parameters and will emit a long low pitched beep.

To cancel Autolearning without saving the configuration parameters, press the keypad button at any time

during the procedure: Matrix-2000™ will emit a long low pitched beep.

Autolearning configuration parameters can be saved to temporary memory only by

selecting the "Autolearning saving mode" parameter in VisiSet™.

The Autolearning function on the keypad button can be disabled by the user via

VisiSet™.

NOTE

MATRIX-2000™ QUICK GUIDE