Dust Free 04967MV Manual de instalación y funcionamiento - Página 5

Navegue en línea o descargue pdf Manual de instalación y funcionamiento para Limpiador de aire Dust Free 04967MV. Dust Free 04967MV 8 páginas. Ultraviolet light systems

Imprimir página

BIO-FIGHTER

NOMAD, NOMAD 2 INSTALLATION & OPERATION MANUAL

INSTALLING THE NOMAD 2

Perpendicular Mount (Fig.4)

Place the Nomad 2 at the desired installation

location/orientation and secure to duct with

the included 1" mounting screws.

Optional spacers are provided to help prevent

"sweating" where insulation is compacted.

When using spacers use the 1.5" mounting

screws included with the Nomad 2.

Lamp repositioning holes.

Fig. 4 Mount the Nomad to the duct using the 1" mounting

screws.

Insert Mount

If installing the Nomad 2 as an insert-mount:

1. Make two 3" diameter lamp holes in the

ductwork.

2. Install lamps as shown on page 5.

3. Remove the retaining screws and bottom

cover of the Nomad 2.

4. Insert the Nomad 2 lamps through the holes

and secure chassis to duct using the provided

1" mounting screws. Any of the holes in the

cover may be used for mounting.

WARNING

Mercury Hazard. Do Not Break.

Each UV-C lamp contains a small amount of Mercury.

May cause redness or irritation. Use proper disposal

techniques in case of breakage. See page 6.

INSTALLING THE LAMP

To maximize the efficiency and life of the UV-C

lamp, clean each lamp prior to installation.

Use isopropyl alcohol and cotton cloth to wipe

dust and fingerprints from the lamp.

Attach lamp to connector by inserting the front

of the lamp into the connector first then gently

snap the back of the lamp in place.

Fig. 5 Attach lamp to connector by inserting the front of the lamp

first then snapping the back of the lamp into place.

WARNING

UV-C Light Hazard.

UV-C light can cause temporary or permanent loss of

vision, and sunburn. Take precautions to protect eyes

and skin from direct exposure.

CAUTION

Clean lamp(s) prior to installation.

Failure to remove dirt and fingerprints from the

lamp(s) could shorten their lifespan.

(Fig. 5)