Dust Free Bio-Fighter VersaLight 1SVL14 Manual de instalación y funcionamiento - Página 5
Navegue en línea o descargue pdf Manual de instalación y funcionamiento para Equipos de iluminación Dust Free Bio-Fighter VersaLight 1SVL14. Dust Free Bio-Fighter VersaLight 1SVL14 7 páginas. 1s and 2s ultraviolet light systems
Imprimir páginaBIO-FIGHTER® VERSALIGHT 1S, 2S INSTALLATION & OPERATION MANUAL
CONNECTING THE HARNESS
With the lamp housing in place attach the con-
nector to the lamp. Hold back the protective
boot to expose the harness connector. The har-
ness connector is asymmetrical and can only be
attached one way. If the harness does not attach
easily, rotate 90 degrees and try again. After the
harness connector is attached, slide the protec-
tive boot over the lamp/connector. The protec-
tive boot fits snugly over the lamp and seals the
connection from moisture, dust, etc.
Fig. 5 Attach lamp harness to lamp. The plastic boot slips over
the lamp and seals the connection from moisture.
INSTALLING THE VIEWPORT
The VersaLight comes with a UV-C safe view-
port that must be installed separately. To
install the viewport, select a location near the
VersaLight installation and drill a 1/2" hole in
the duct. Then press the viewport into the hole.
CONNECT POWER AND CHECK OPERATION
With the cover replaced, connect the
VersaLight to proper power. If optional whip-
type power cord (#06303) is used see fig. 8
for power connection.
The device power switch must be turned on
and device checked for operation using the
viewport. The lamp(s) should be radiating a
bright blue light.
(Fig.5 )
Fig. 8 Optional whip-type power cord.
OPERATION
Under normal conditions the Bio-Fighter®
VersaLight should be operated continuously to
extend the life of the lamp(s), and to increase
the effectiveness in disinfecting the location
selected.
A convenient power switch is located on the
device, and should be turned off before any
maintenance on the device or HVAC system is
performed.
TROUBLESHOOTING
Maintenance and troubleshooting should be
performed by a qualified technician.
Device fails to operate. (On/Off switch light is
not lit.)
1. Check that device is connected to proper
2. Check that fuse is in good working order.
Device fails to operate. (On/Off switch light is lit.)
1. Check that device is connected to proper
2. Check that ballast is receiving correct
3. Check continuity of lamp filaments. Replace
4. Check that lamp is properly connected to
5. Check that wires are properly connected to
5
Whip-type Power
Cord Option
Connect black
and white wires
to proper power.
power.
Replace with 250V/3A fuse if necessary.
power.
power. Replace ballast if necessary.
lamp if necessary.)
lamp connector.
lamp and ballast.
Connect green wire
to ground.