Dust Free Bio-Fighter VersaLight 2SVL20 Manual de instalación y funcionamiento - Página 4

Navegue en línea o descargue pdf Manual de instalación y funcionamiento para Equipos de iluminación Dust Free Bio-Fighter VersaLight 2SVL20. Dust Free Bio-Fighter VersaLight 2SVL20 7 páginas. 1s and 2s ultraviolet light systems

Imprimir página

BIO-FIGHTER® VERSALIGHT 1S, 2S INSTALLATION & OPERATION MANUAL

REMOTE LAMP MOUNTING

Remove the remote lamp housing from the

remote lamp base by removing the knurled

nuts. Then install the remote lamp base to the

surface with the includes mounting screws.

Using the remote lamp base as a template,

drill a 1" hole for the lamp. Repeat for the sec-

ond lamp base if applicable.

Fig. 2 Lamp is secured with a sliding bracket tightened with two

knurled nuts.

CAUTION

Sharp Edge Hazard.

Be careful of sharp edges on device and

HVAC equipment while installing the device.

Personal injury may result.

CAUTION

Clean lamp(s) prior to installation.

Failure to remove dirt and fingerprints from

the lamp(s) could shorten their lifespan.

WARNING

UV-C Light Hazard.

UV-C light can cause temporary or permanent loss of

vision, and sunburn. Take precautions to protect eyes

and skin from direct exposure.

(Fig.2)

INSTALLING THE LAMP

To maximize the efficiency and life of the UV-C

lamp, clean each lamp prior to installation.

Use isopropyl alcohol and cotton cloth to wipe

dust and fingerprints from the lamp.

Gently insert the lamp into the lamp hole.

Slide the bracket over the the retaining lip of

the lamp and tighten the two knurled nuts until

the lamp is securely fastened. The lamp seals

against the base of the unit using a rubber

grommet which prevents air leaks. Repeat for

each lamp of the installation.

Fig. 3 Lamp is secured with a sliding bracket tightened with two

knurled nuts.

REMOTE LAMP HOUSING

After lamp has been installed, reinstall the

remote lamp housing using the knurled nuts.

The remote lamp housing must be in place

prior to attaching the electrical harness.

Fig. 4 Reinstall lamp housing.

(Fig.3)

(Fig.4 )