elsner elektronik P03/3-RS485-WAGO Manual - Página 11
Navegue en línea o descargue pdf Manual para Estación meteorológica elsner elektronik P03/3-RS485-WAGO. elsner elektronik P03/3-RS485-WAGO 12 páginas. Meteorological station
Imprimir páginaMounting the meteorological station
Close the housing by putting the cover back over the bottom part. The cover must snap
in on the left and right with a definite "click".
To remove it, the meteorological station can be simply pulled upwards out of the
mount, against the resistance of the fastening.
Notes on installation
Do not open the P03 meteorological station if water (rain) could get in: even a few drops
could damage the electronics inside.
When mounting, you must take care not to damage the temperature sensor (small PCB
on the bottom of the housing). Also, the wire connecting the PCB with the rain sensor
must not be pulled off or kinked at the terminal.
Remove all existing protection labels after installation.
It will take 30 seconds after applying the power before the wind measurement will be
output.
Maintenance
The meteorological station must be checked for dirt on a regular, twice-yearly basis and
cleaned if necessary. A dirty meteorological station can lead to strange results, such as
the wind sensor failing to work, the station constantly announcing rain, or failure to
detect sunlight.
Meteorological Station P03/3-RS485-WAGO • Version: 11.10.2011 • Subject to technical alterations. Errors excepted. 11
Fig. 10
Make sure the cover and bottom part are properly
snapped together! This picture is looking at the
closed meteorological station from underneath.
Fig. 11
Push the housing from above into the fastened
mount. The bumps on the mount must snap into
the rails in the housing.