Datalogic QLM500 Manual de instalación - Página 12

Navegue en línea o descargue pdf Manual de instalación para Lector de códigos de barras Datalogic QLM500. Datalogic QLM500 17 páginas.

Imprimir página
Datalogic QLM500 Manual de instalación
QLM500 INSTALLATION MANUAL

TYPICAL LAYOUTS

The following figure shows the general system layout.
Reading
Device
QLM500
Power
ID-NET™
Trigger
The dotted lines in the figure refer to optional hardware configurations.
The general system layout allows the QLM500 EtherNet/IP Gateway to connect one of the
compatible serial reading devices (2KN, 4K Scanner), collect its information and send it to an
EtherNet/IP Host.
In a daisy chain topology, the EtherNet/IP network from the Host is connected to one of the
two QLM500 EtherNet/IP ports. The other EtherNet/IP port connects either to the next
EtherNet/IP node or is left unconnected (sealed by the protection cap).
In a star topology, one of the two EtherNet/IP ports is connected to an Ethernet switch; the
other port remains unconnected.
The reading device connects to the 25-pin connector.
The ID-NET™ interface allows a network of ID-NET™ Slaves to be connected to the
QLM500's reading device which acts as the ID-NET™ Master.
The reading device auxiliary interface signals are available on the AUX connector which can
be quickly connected to a portable PC for reader configuration.
12
Auxiliary
Interface
or
to next EtherNet/IP node
from previous EtherNet/IP node
or
I/O
Figure 4 – General System Layout
protection cap
from EtherNet/IP PLC (Host)
Reader
Configuration PC