Datalogic POWERSCAN PBT7100 guide Manual de consulta rápida - Página 10
Navegue en línea o descargue pdf Manual de consulta rápida para Terminales táctiles Datalogic POWERSCAN PBT7100 guide. Datalogic POWERSCAN PBT7100 guide 16 páginas. Cordless imaging reader
También para Datalogic POWERSCAN PBT7100 guide: Manual de consulta rápida (20 páginas)
Imprimir página
Host Connection —
your reader and/or Base Station was ordered, however you should verify
before connection that the Base Station's cable type is compatible with
your host equipment. Most connections plug directly into the host
device as shown in
connection where its female end mates with the male end of the cable
from the keyboard and the remaining end at the keyboard port on the
terminal/PC.
Figure 2. Connecting to the Host
Linking the Reader to a Base Station
To link a reader to a Base Station, press the Link Button on the Base Sta-
tion (see
Figure 3
Mode"then scan the link barcode located on the Base Station itself using
the reader to be linked. Allow the system several seconds to create the
association between the two units and exit Link Mode. A successful link
is indicated by three ascending tones from the reader. A "high-low-high-
low" tone indicates the link attempt was unsuccessful. A single LED
flash during this tone indicates no Base Station was discovered. Two
green LED flashes during this tone indicates that more than one Base
Station was discovered and the reader did not link.
8
Typically, the interface type was specified at the time
. Keyboard Wedge interface cables have a 'Y'
Figure 2
or...
or...
or...
) for at least one second to place the base in "Link
PowerScan
PBT7100 Base Station
®