DuTCH audio IM1.3 Manual - Página 3

Navegue en línea o descargue pdf Manual para Equipos de grabación DuTCH audio IM1.3. DuTCH audio IM1.3 6 páginas.

Operation:

Input:

Active gain:

The input is passive with just relays, but by pushing the 'active gain' button you will enable

the active gain stage which enables you to change the input gain to your liking. In the

mid/0 position, there is no gain applied though it passes the active gain circuit. You can

change the gain in 23x0.5dB steps from +5.5dB to -5.5dB with stepped switches.

Inserts:

Insert 1 and 2:

This is a 100% passive insert section with just relays. When disabled, it will directly pass

the signal internally to the next stage. When you enable the insert (1 and/or 2), it will pass

the signal to the corresponding send/return. It will first pass insert 1 and then it goes into

insert 2. When you push the 'swap 1 /2' button, it will swap the order of the inserts. So

instead of 1>2 it will become 2>1.

Insert 3 and 4 (mid/side):

Insert 3 and 4 can be used for Mid/Side processing. When set to stereo, it will be 100%

passive, when set to MS, it will pass the active mid/side circuit.

Mid Side:

When the 'stereo/ms' button is engaged, both inserts 3 and 4 will work in MS mode. Left

channel is Mid (sum), Right channel is Side (diff). You should keep in mind that the sum

could/will be louder then the diff channel because of the LR summing/gain buildup.

Insert 5 and 6:

This is a 100% passive insert section with just relays. When disabled, it will directly pass

the signal internally to the next stage. When you enable the insert (5 and/or 6), it will pass

the signal to the corresponding send/return. It will first pass insert 5 and then it goes into

insert 6. When you push the 'swap 5/6' button, it will swap the order of the inserts. So

instead of 5>6 it will become 6>5.

Insert 7 and 8:

This is a 100% passive insert section with just relays. Insert 7 is a regular passive insert.

With insert 8 you can swap the order of insert 8 from insert 8 to pre insert 1, so it basically

becomes insert 0. When you push the '6 pre/post' button, this is what will happen:

8 pre/post off: inputs > 1>2>3>4>5>6>7>8> outputs

8 pre/post on: inputs > 8>1>2>3>4>5>6>7> outputs

Output:

Bypass:

When you press the 'bypass' button, all inserts will be bypassed at once. The bypass button

becomes red and all other buttons will be 'greyed out'. This way, the input goes directly to

the output with nothing inline except for some relays.