4M Clever Cleaning Robot Manual de instrucciones - Página 2

Navegue en línea o descargue pdf Manual de instrucciones para Juguete 4M Clever Cleaning Robot. 4M Clever Cleaning Robot 2 páginas.

D. ASSEMBLY:

1. Insert the axle (6) and it's two wheels into the slot on the bottom of the cleaner body (1). Screw in the axle cover (7) to secure it in

place.

2. Turn the body over and insert the motor (10) into its slot. Make sure that the worm gear on the motor interlocks with the gear wheel on

the base.

3. Place the bare metal ends of the black wires from the motor and the battery case into one terminal. Push a terminal cap (14) into the

terminal to secure the wires in place. Repeat with the two red wires in the other terminal.

4. Put the body cover over the motor and secure it with three screws.

5. Remove the backing from the two eye stickers (13) and stick one into each eye support (12). Push the eye supports into their holes in

the base. Snap the handle (3) into place and secure it with a screw (11).

6. Remove the layer of film from the back of the fastening pads (8) and stick them inside the lines engraved on the body as shown in the

diagram. To secure the fabric duster, two of the pads must be stuck next to each other.

7. Carefully remove the singular string from the bottom of the fabric duster (5) so the fabric strands can move freely.

8. Press one end of the duster's band against one of the two fastening pads that are next to each other. Stretch the fabric duster around

the body, pressing it onto the other fastening pads.

Important: Make sure the strands of the fabric duster face away from the body to ensure that the wheels can move smoothly.

9. Fold up the ribbon and tie it up with the thinner ribbon before you attach it to the robot. Excellent work! Your Clever Cleaning Robot is

ready to roll.

10. Insert two AA batteries into the battery compartment in the robot's base, making sure the poles are the correct way round (the flat

end of the battery always goes against the spring). If the motor begins to run, flick the robot's switch on the base to turn the motor off.

Secure the battery compartment cover with a screw. Flick the base's switch to turn the motor on and place the Clever Cleaning Robot on

the floor.

11. Find a smooth floor for your Clever Cleaning Robot to explore. Watch it move across the floor, collecting dust as it goes. When it hits

an obstacle it will turn or reverse to carry on with its job.

12. After a few minutes, pick up and switch off the Clever Cleaning Robot and tap any dust or hairs into a bin.