4M Disney Frozen II Code A Maze Manual - Página 3

Navegue en línea o descargue pdf Manual para Juguete 4M Disney Frozen II Code A Maze. 4M Disney Frozen II Code A Maze 16 páginas.

Imprimir página

Storage

1. Keep your CODEAMAZE

CODEAMAZE

Frozen II and keep the parts clean.

2. Do not fold or wrinkle the maze mats when storing them.

Trouble shooting

1. If Elsa (that is the one mount on the large base) is not moving, check the battery level and

ensure that the batteries are inserted in the correct position. Check that the switch is turned on.

2. If Elsa is not properly attached to the grid mechanism inside of the main board, use the

any other position card) to reset the grid mechanism and place Elsa back into the starting position. Elsa

will be attracted to the main board.

3. If the device beeps twice after you scan a code card, this indicates that the card was not scanned

successfully. If this occurs, try scanning the card again.

4. If Elsa does not move according to the codes stored, check that the

edges of the code card are properly aligned with the scanner, otherwise

any light that passes through the gap may affect the scanning process

and cause Elsa to move in a random manner.

5. Replace the batteries when the small LED starts to flash.

6. If you make an error when entering code cards, scan the

CLEAR card to remove all stored codes and start again. You can also

turn the main board off and on again to clear the codes and reset the

grid mechanism.

7. If left idle for 10 minutes or more, the main board will enter sleep

mode. You can wake it up by pressing the scan button or switching it

off and on again.

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may cause undesirable operation.

CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC rules. These limits are designed

to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy

and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for assistance.

Product name: CODEAMAZE

Frozen II

Model No: 00-06202

Trade name: 4M Industrial Development Limited

Frozen II in the package box. Always take good care of the

QUICK START GUIDE

card (or