Datamate M83 Series Manual - Página 4

Navegue en línea o descargue pdf Manual para Cables y conectores Datamate M83 Series. Datamate M83 Series 16 páginas. Rectangular connectors

Imprimir página
3. RATINGS (continued)
3.1.2. Environmental characteristics (continued)
Acceleration severity ............................................................................................................... 490m/s² (50G)
*The connector will function correctly using a simultaneous combination of high temperature and low air
pressure down to 300mbar (Altitude of 9,144M/30,000ft) up to 360V DC.
3.1.3. Mechanical characteristics
Durability ................................................................................................................................ 500 operations
Clip retention in body .............................................................................................................. 18N min
Minimum retention force may be 10N from a sample of 10 sockets, providing the average of the
samples is 22N.
High temperature, long term (current as in 3.1.) ........................................................1000 hours at 85°C
High temperature, short term (no electrical load) ......................................................250 hours at 125°C
Contact retention in moulding ..................................................................................................... 10N min*
Male Crimp Jackscrew contact replacement – 2 operations at 10N
*
Contact holding force ...................................................................................................................... 0.2N min
M80 insertion force (per contact, using mating pin, no latch fitted)...................... ...................... 2.0N max
M80 withdrawal force (per contact, using mating pin, no latch fitted).................. ..................... 0.2N min
M83 insertion force (per contact, using mating pin, no latch fitted)...................... ...................... 1.0N max
M83 withdrawal force (per contact, using mating pin, no latch fitted)................... ..................... .0.2N min
3.1.4. Wire Termination Range
Wire type (recommended) ................................................................................................ BS 3G 210 Type A
Crimp Type
Crimp Type
Crimp Type
Crimp Type
No. & Nominal dia. (mm) of wires
A.W.G.
Minimum pull-off force
M22520/2-01 Crimp tool setting
Max. insulation diameter
Extra small bore crimp contact details
No. & nominal dia. (mm) of wires
M22520/2-01 crimp tool setting
Max. insulation diameter
3.2.
COAX CONTACTS
3.2.1. Electrical characteristics
Impedance ............................................................................................................................................. 50Ω
Frequency Range ................................................. 6GHz (Also dependent on cable type or board layout)
COMPONENT SPECIFICATION
Small Bore
Small Bore
Small Bore
Small Bore
7 / 0.12
28
12.5N
6
Crimp type
Crimp type
Crimp type
Crimp type
AWG
Min. pull off force
- 4 -
Small Bore
Small Bore
Small Bore
Small Bore
Small Bore
Small Bore
Small Bore
Small Bore
7 / 0.15
7 / 0.2
26
24
25N
44N
6
6
Ø1.10mm
Extra small bore
Extra small bore
Extra small bore
Extra small bore
7/0.12
1/0.25
7/0.08
28
30
32
12.5N
7N
4N
5
4
4
Ø0.75mm
C00525
C00525
C00525
C00525
Large Bore
Large Bore
Large Bore
Large Bore
19 / 0.15
22
50N
6