Datamax I-Class Manual del usuario - Página 6

Navegue en línea o descargue pdf Manual del usuario para Etiquetadora Datamax I-Class. Datamax I-Class 15 páginas. Present sensor option
También para Datamax I-Class: Manual de inicio rápido (4 páginas), Manual de inicio rápido (6 páginas)

Imprimir página



'FAULT HANDLING'

label when a fault (ribbon out, paper out, unreadable barcode, etc.) occurs.

Level –

Void Distance – .10 – 2.00

Retry Count

– 0 – 3

is used to determine the level of interaction, as well as the disposition of the

Determines the printer's action, the action required by the operator, and the

label's reprint status with the following three selections:

Void and Retry

– Depending upon the RETRY COUNT, one of the following

actions when faulted:

 If the Retry Count setting (see below) has not been

exceeded, 'VOID' is printed on the label in process and

reprinting occurs automatically;

 If the Retry Count has been exceeded, printing stops and a

fault message is displayed. After the problem is corrected,

the FEED Key must be pressed to clear the fault. The label

in process is reprinted; or,

 If the CANCEL Key is pressed, the operator now has the

option of canceling the reprint:

To allow the reprint, press the ESC Key; or, to cancel the

reprint, press the ENTER Key. (If the ENTER Key was

pressed, the operator now has the option of canceling the

entire label batch by pressing the ENTER key again

 Note: VOID will not be printed w hen insufficient space exists

No Reprint

– Printing stops and a fault message is displayed. After the

problem is corrected, the FEED Key must be pressed to clear

the fault. The label in process is not reprinted.

Standard

– Printing stops and a fault message is displayed. After the

problem is corrected, the FEED Key must be pressed to clear

the fault. The label in process is reprinted. (This is the

default setting.)

Sets the distance to backup the faulted label to print 'VOID'

on its trailing edge, which also indirectly establishes the font

size of the void message. (The default setting is .50 inch.)

Establishes the number of times the printer will attempt to

reprint a label. If the last label printed in this count has been

voided, the printer will stop and display a fault message.

(The default setting is 1.)

for the height of the text (see Void Distance, below ) or

if the fault occurred after the

completed (i.e., w hen the l abel reaches its Present

Distance at or above the Top Of Form).

entire label was