Datapath VisionAV-HDAudio/Video Capture Card Manual del usuario - Página 6
Navegue en línea o descargue pdf Manual del usuario para Tarjeta PCI Datapath VisionAV-HDAudio/Video Capture Card. Datapath VisionAV-HDAudio/Video Capture Card 15 páginas.
Imprimir página
Installing the Capture Card
You are likely to need a flat blade and /or a cross head screwdriver for the installation of the
VisionAV-HD card; it would be useful to have these to hand before you begin.
• Power down the PC (including peripherals), switch off at the mains and disconnect all the cables
connected to the computer, noting the positions for accurate reconnection
• Remove the PC cover
• Locate a vacant PCI Express slot (x4 or higher) on the motherboard and remove the blanking plate
(retain all screws)
If you are in doubt consult your motherboard documentation to correctly identify a PCI Express slot. If
the card is forced into a 32 or 64 bit PCI or PCI-X slot it will be irreparably damaged when the system is
powered up and the warranty will be
• Reconnect all cables to the PC then connect a DVI cable (not supplied) distributing the DVI source
signal to the connector on the VisionAV-HD capture card
• A standard definition signal can be connected to the RCA connector on the VisionAV-HD
• An Audio feed can be connected to the Audio Module via the Audio Breakout Cable
• Power up the PC and commence the software installation
How to Connect Input Sources
The VisionAV-HD card has two DVI-I and one RCA (female) connectors, The DVI-I connectors support DVI,
HDMI, Component and RGB (VGA) inputs using the supplied adapters where required.
A DVI input is connected directly into the DVI-I connector which accepts DVI-D (digital) or DVI-A (analog)
inputs:
void.
5