Datapath Mosaic-HQ Manual del usuario - Página 7

Navegue en línea o descargue pdf Manual del usuario para Tarjeta de vídeo Datapath Mosaic-HQ. Datapath Mosaic-HQ 13 páginas.

Install and configure all the required graphics cards in the system, carefully

following the installation instructions. Ensure that your multi-screen system is

working correctly before installing the Mosaic-HQ card.

Note:

You are likely to need a flat blade and a Phillips head screwdriver for the

intallation so please ensure you have these to hand before you begin.



Power down your complete system (including peripherals) at the PC

and the main power supply.



Disconnect all the cables connected to the PC, noting the positions

for correct reconnection after the Mosaic-HQ card is installed.

Carefully remove the cover from your PC.



Locate an available PCI slot to install your Mosaic-HQ card next to

your graphics card.



Holding the card firmly by its top edge at each end of the card's

length, slide it into the slot. Care should be taken when sliding the

card into the PCI slot.



Using the retaining screw, secure the bracket to the back panel.

Connect the SIP-Cable from the Mosaic-HQ card to graphics cards. The

headers on the Mosaic-HQ cards are marked J9 and J10 and should be

connected to the graphics cards as follows:

Connect the J9 header on the Mosaic-HQ to the J7 headers on the graphics

card.

The SIP cable is delicate and great care should be taken when fixing it and

removing from the cards.

The diagram (1) on the following page shows the location of the headers on

each of the cards:

Diagram 1