Dux Radiant 170AN Manual del usuario - Página 10

Navegue en línea o descargue pdf Manual del usuario para Calentador de agua Dux Radiant 170AN. Dux Radiant 170AN 18 páginas. Gas storage water heater

DO NOT operate with panels or covers removed from the appliance.

FILLING THE WATER HEATER

Open all hot water taps. Open stop cock at the cold water inlet and allow water heater to

fill until water flows through the system. Close each hot water tap after the air is expelled

from its line.

LIGHTING THE WATER HEATER

The water heater must be filled with water before lighting.

Instructions for lighting

procedure are on the inside of the access cover and shown in Figure 4.

The access cover is removed by lifting the cover upwards and away from the water heater.

The unit is fitted with a thermostat that incorporates a Thermal Overload Safety Cut-Out. In

the event of thermostat failure, the Safety Cut-Out will automatically and permanently cut

off the supply of gas to the burner. If this happens, your heater will not light and you should

call your local Dux agent.

FITTING OF PLUMBING INSULATION CAPS

To ensure optimum operating efficiency of the water heater the two Plumbing Insulation

Caps supplied with the water heater must be fitted to the two brass plugs (also provided

with the water heater) used to seal the unused hot and cold water connection fittings on

these dual handed plumbing featured models. Refer Figure 3 below: