AusClimate WDH-716DE Manual del usuario - Página 7

Navegue en línea o descargue pdf Manual del usuario para Deshumidificador AusClimate WDH-716DE. AusClimate WDH-716DE 14 páginas.

OPERATING INSTRUCTIONS

● Start Operation

1) Place the product in an upright position on a flat, steady,

stable, heat-resistant surface. Make sure there is nothing

flammable or heat sensitive within 100 cm (39 inches).

Operating the product in any other position could cause a

hazard.

2) Insert the plug into a suitable wall socket. The dehumidifier

is suitable for operation on an electricity supply having the

same voltage as that shown on its rating label.

3) Make sure the water tank is correctly located. (After

switching on the machine for the first time, if the "Bucket

Full" lamp illuminates, just pull out the water tank, check

the "float" lever is able to move freely, then return the water

tank to the correct position.)

● When Bucket Full Light Is On

When the water tank is full the machine will stop and the "Bucket Full" light

will illuminate. The water tank should be carefully removed from the

machine by sliding it outwards from the front of the machine and it should be

emptied. When the empty tank is replaced properly into the machine, the

machine will start up and run normally.

DEFROST

When operating in low temperatures the surface of the dehumidifier's coil may

accumulate ice and effect the efficiency of the dehumidifier. When this happens

the machine will go into periodic defrost mode automatically. This is quite normal.

Defrost icon

continue to operate until the ice has thawed. As soon as the ice has melted, the

compressor will restart and continue the dehumidifying process. Defrost time may

vary depending on room temperature and humidity.

will come on, the compressor will cease operating and the fan will

Please use both hands to

carefully empty the water tank.