Aussie Scud 350 Manual de uso y mantenimiento - Página 5

Navegue en línea o descargue pdf Manual de uso y mantenimiento para Lavadora a presión Aussie Scud 350. Aussie Scud 350 13 páginas. Aussie scud series
También para Aussie Scud 350: Manual de instrucciones del operador (16 páginas)

Imprimir página
Feb 2012
KEEP THE MACHINE OUT OF MOISTURE LADEN ATMOSPHERES
HIGH PRESSURE SPRAY CAN PENETRATE THE SKIN AND CAUSE SERIOUS INJURY!
NEVER POINT THE SPRAY GUN AT YOURSELF, OTHER PEOPLE OR ANIMALS.
SHOULD SPRAY PENETRATE THE SKIN, SEEK MEDICAL ATTENTION IMMEDIATELY!
E.

Pressure washing

WEAR PROPER FACE PROTECTION WHEN OPERATING PRESSURE WASHER!
1.
For high pressure jetting rotate side grip on dual lance backwards until it stops. Fine control of pressure/
flow can be made with small adjustments to the rotation of the grip. There is no pressure adjustment
available on single lance options.
2.
When low pressure and high flow is required, including detergent application, unwind grip two complete
turns. Adjust the detergent control on the pump as required.
NOTE: Check the system for water leaks, fuel leaks, oil leaks, hose kinks, etc. Correct any problems before
proceeding.
Machine is now ready for operation.
SWITCH MACHINE OFF WITHIN TWO MINUTES OF CEASING OPERATION AS EXCESSIVE BY-PASS CAN CAUSE
F.
Applying detergent (not available on Predator Plus)
1.
Prepare pressure washer detergent solution as required by manufacturer.
2.
Place detergent siphon tub/filter into solution.
3.
Adjust double lance to low pressure setting.
4.
Apply cleaning solution to a dry surface, starting at lower portion of areas to be washed and work upward,
using long overlapping strokes.
5.
Allow time to detergent to activate and then rinse off. DO NOT allow detergent to dry on.
IMPORTANT; You must flush the injection system after each use by placing siphon hose into a bucket of clean
water, then run pressure washer in low pressure for 2 minutes.
G.

Stopping the machine

1.
If using the detergent injector, flush out the chemical by running clean water through the system.
2.
Allow machine to run for 1 minute without load to cool before stopping.
3.
Turn engine ON/OFF switch to OFF
4.
If your machine has a recoil start, pull recoil start until compression resistance is felt. Store the machine in
this position to help prevent valve warpage or sticking.
5.
Close fuel valve.
FAILURE TO CLOSE THE FUEL VALVE ON THE ENGINE CAN CAUSE FUEL LEAKAGE WHEN THE MACHINE
IS BEING TRANSPORTED!
6.
Turn off water supply.
7.
Pull gun trigger to release all pressure in the system, then LOCK THE TRIGGER.
8.
Hoses may now be disconnected from the machine.
Failure to release pressure before disconnecting the hose quick coupler will result in the quick coupler o-ring
seal blowing out. This o-ring must be replaced before operating machine.
WARNING .... DO NOT RUN EXCESSIVE BY-PASS
HEAT BUILD UP IN PUMP AND SUBSEQUENT DAMAGE.
EXCESSIVE BY PASS RUNNING VOIDS WARRANTY!!
Aussie Scud & Ultra ... Operation & Maintenance Manual
Aussie Pumps
5