Datatool S4 Manual - Página 2

Navegue en línea o descargue pdf Manual para Accesorios para motocicletas Datatool S4. Datatool S4 2 páginas.

Coding new transmitters, changing siren tones, passive arming selection

It will not be possible to follow the procedures below without first having registered a PIN number to the alarm system

Enter PIN number (after last number has been entered a long tone will be heard)

Turn ON Ignition switch then press Grey button on a new or existing transmitter

If new transmitter - (The new transmitter will now have been coded to the alarm)

If only programming a new transmitter leave the ignition switch off for at least 15 seconds

To proceed to siren tone or passive arming section (Software Switches) turn Ignition back ON

Software Switch number

Toggle to desired Switch

Switch 1 (For customer use)

Change siren tones

Press Grey button to toggle to

switch 2 &3

(Alarm will beep once to confirm

switch number)

Switch 2 (For customer use)

Alarm arming method

(Alarm will beep twice to confirm

switch number)

Switch 3

(For dealer use only)

Entry to Engineer Switches

Press Black button to toggle to

switch 2 & 1

(Alarm will beep three times

to confirm switch number)

Press Grey button on transmitter or enter PIN number to disarm alarm

Turn Ignition switch ON, OFF, ON, OFF, ON (within 7 seconds)

Turn OFF Ignition switch (Two tones will be heard)

Within 15 seconds of hearing these tones

Press buttons as shown below

to enter desired Switch

Press

For dealer use only

Method of altering setting and accepting

To exit Software switches at any time turn Ignition

switch off for at least 15 seconds

Black button = Previous tone

Press Both buttons to save and exit back to switch selection

Grey button/LED ON = Full passive arming

Black button/LED OFF = Passive Immobiliser

Press Both buttons to save and exit back to switch selection

Grey button = Next tone

(Default)

For dealer use only