AUSSIE TONNEAU ATB01234 Instrucciones de montaje - Página 2
Navegue en línea o descargue pdf Instrucciones de montaje para Accesorios para automóviles AUSSIE TONNEAU ATB01234. AUSSIE TONNEAU ATB01234 4 páginas. For 2012 dmax dual cab with out head board
Imprimir páginaRivet the aluminium rope track into
position.
STEP 2: FIT SUPPORT BAR
Mark the inside edge on each side of the tub at 740mm from the inside front face of tub towards
the rear on each side. Centrally locate the bar bracket over this position and align the top of the
bar bracket 10mm down from the top edge of the tub and drill and rivet bracket into place. See
Figure 4. Repeat for other side of tub. Use instruction over page to fit tonneau support bar.
10mm
down from
top edge of
tub
Figure 4
STEP 3: FIT BUTTONS TO VEHICLE
Slide the front of the tonneau cover through the aluminium rope track section.
Ensure tonneau is centred. Start with the tailgate.
Vertically line up each button to each bunji loop starting from the centre bunji loops.
The height for the buttons on the tailgate is 410mm UP from the bottom edge of the tailgate.
Work from the centre out, alternating from side to side. Attach each bunji to the button as it is
fitted.
To fit the rope buttons to the sides:
Vertically line up each button to each bunji loop starting from the rear bunji loop, alternating from
side
to side working towards the front.
The height for the side rope buttons are all measured down from the TOP INSIDE EDGE of the
tub.
For the rear button measure 160mm, 165mm for the second button from the rear, and 170mm for
the
next two buttons.
For the button closest to the front of the tub measure 175mm down and 25mm back from the front
edge of the tub. Attach each bunji to the button as it is fitted.
Place the bar bracket
with the beveled edge
facing up.
Figure 3
740mm
Front of car